Re: [PATCH v8 3/7] thermal/drivers/tsens: Add TSENS enable and calibration support for V2

[Manikanta Mylavarapu <quic_mmanikan@quicinc.com>]

On 11/22/2024 6:05 PM, Konrad Dybcio wrote:
> On 15.11.2024 11:39 AM, Manikanta Mylavarapu wrote:
>> From: Praveenkumar I <quic_ipkumar@quicinc.com>
>>
>> SoCs without RPM need to enable sensors and calibrate them from the kernel.
>> The IPQ5332 and IPQ5424 use the tsens v2.3.3 IP and do not have RPM.
>> Therefore, add a new calibration function for V2, as the tsens.c calib
>> function only supports V1. Also add new feature_config, ops and data for
>> IPQ5332, IPQ5424.
>>
>> Although the TSENS IP supports 16 sensors, not all are used. The hw_id
>> is used to enable the relevant sensors.
>>
>> Signed-off-by: Praveenkumar I <quic_ipkumar@quicinc.com>
>> Signed-off-by: Manikanta Mylavarapu <quic_mmanikan@quicinc.com>
>> ---
> 
> [...]
> 
>> +{
>> +	u32 shift = V2_SHIFT_DEFAULT;
>> +	u32 slope = V2_SLOPE_DEFAULT, czero = V2_CZERO_DEFAULT, val;
> 
> Please don't mix initialized and uninitialized variables in the same line,
> I think it would be the cleanest if you initialized the ones you want on
> separate lines and then declared val separately as well (and preferably
> in reverse-Christmas-tree order)
> 
> [...]
> 

Sure. I will update in next series.

>> +	}
>> +
>> +	val =	FIELD_PREP(CONVERSION_SHIFT_MASK, shift) |
> 
> tab->space after '='
> 
> [...]
> 

Sure. I will update in next series.

>> +	/* Select temperature format, unit is deci-Celsius */
>> +	regmap_field_write(priv->rf[CODE_OR_TEMP], RSEULT_FORMAT_TEMP);
> 
> "result"?
> 

Sure. I will update in next series.

Thanks & Regards,
Manikanta.