Re: [PATCH] pwm: sun4i: Fix incorrect calculation of duty_cycle/period

Uwe Kleine-König
2019-10-14T16:23:35Z

On Mon, Oct 14, 2019 at 03:53:03PM +0200, megous@megous.com wrote:
> From: Ondrej Jirman <megous@megous.com>
>
> Since 5.4-rc1, pwm_apply_state calls ->get_state after ->apply
> if available, and this revealed an issue with integer precision
> when calculating duty_cycle and period for the currently set
> state in ->get_state callback.
>
> This issue manifested in broken backlight on several Allwinner
> based devices.
>
> Previously this worked, because ->apply updated the passed state
> directly.
>
> Fixes: deb9c462f4e53 ("pwm: sun4i: Don't update the state for the caller of pwm_apply_state")
> Signed-off-by: Ondrej Jirman <megous@megous.com>
> ---
> drivers/pwm/pwm-sun4i.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pwm/pwm-sun4i.c b/drivers/pwm/pwm-sun4i.c
> index 6f5840a1a82d..05273725a9ff 100644
> --- a/drivers/pwm/pwm-sun4i.c
> +++ b/drivers/pwm/pwm-sun4i.c
> @@ -137,10 +137,10 @@ static void sun4i_pwm_get_state(struct pwm_chip *chip,
>
> val = sun4i_pwm_readl(sun4i_pwm, PWM_CH_PRD(pwm->hwpwm));
>
> - tmp = prescaler * NSEC_PER_SEC * PWM_REG_DTY(val);
> + tmp = (u64)prescaler * NSEC_PER_SEC * PWM_REG_DTY(val);
> state->duty_cycle = DIV_ROUND_CLOSEST_ULL(tmp, clk_rate);
>
> - tmp = prescaler * NSEC_PER_SEC * PWM_REG_PRD(val);
> + tmp = (u64)prescaler * NSEC_PER_SEC * PWM_REG_PRD(val);
> state->period = DIV_ROUND_CLOSEST_ULL(tmp, clk_rate);

The issue is real and the fix looks right. So take my

Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>

There are a few more issues though:

- The dty value is calculated as (simplified):

dty = prd * state->duty_cycle / state->period

which gives suboptimal values in some cases.

- The algorithm does 2 divisions (and one too early) instead of a single
one at the end, which is both ineffective and gives away precision.

- the test in sun4i_pwm_apply about cstate.period != state->period and
the same for duty is probably less useful now because it compares
requested values with actually implemented ones.

- it's unclear what the "surprising values" are that sun4i_pwm_calculate
talks about in a comment. (And IMHO you should always round down.)

- Having a comment describing the implemented duty_cycle and period
depending on how the registers are set would be helpful to understand
the implemented algorithm.

- If there is a publically available datasheet adding a link to it in
the header of the driver would be great.

Best regards
Uwe

--
Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | http://www.pengutronix.de/ |