From mboxrd@z Thu Jan 1 00:00:00 1970 From: Evan Felix Subject: Re: 3ware JBOD Date: Mon, 01 Mar 2004 12:50:20 -0800 Sender: linux-raid-owner@vger.kernel.org Message-ID: <1078174220.3010.13.camel@e-linux> References: <40429940.9000408@sauce.co.nz> Mime-Version: 1.0 Content-Type: text/plain Content-Transfer-Encoding: 7bit Return-path: In-reply-to: <40429940.9000408@sauce.co.nz> To: Richard Scobie Cc: linux-raid@vger.kernel.org List-Id: linux-raid.ids You will have to look In the bios setup screens to make sure all the drives are in the 'Available Drives' Section. If I remember right they have to be here to show up in linux as separate drives. It may be holding the drives as 'previously used' and not as availible. These options may be different as I think we have different Cards than you. Evan On Sun, 2004-02-29 at 18:00, Richard Scobie wrote: > I have a 3ware 7506-4LP with 4 x 250 which when first installed showed > up in the system as SCSI devices sda-d. > > I built and tested various software RAID arrays on it, then decided to > try various hardware arrays, which tested fine. > > Wishing to go back and build some more linux software arrays, I used the > 3ware CLI utility to delete the array. > > Now, when I boot up, although all 4 drives show up in the 3ware BIOS, > dmesg now shows: > > SCSI subsystem driver Revision: 1.00 > 3ware Storage Controller device driver for Linux v1.02.00.037. > 3w-xxxx: No valid units for card 0. > scsi0 : Found a 3ware Storage Controller at 0x7000, IRQ: 28, P-chip: 1.3 > scsi0 : 3ware Storage Controller. > > Can anyone please tell me how I get to see sda-d again? > > Regards, > > Richard > > - > To unsubscribe from this list: send the line "unsubscribe linux-raid" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html