Raid 5 Issue, cannot recognize EXT3 File system.

["Sunpyo Hong" <sunpyo.hong@amac.com>]

I’ve contacted just about everyone that knows a thing about RAID5, but no
one is really able to help me. Anyhow I’ve read up a lot on RAID5 arrays and
how to properly assemble them. However I’ve run into a problem with a NAS
system from WD that I just can’t seem to figure out.

I have a ¾ disks in the array, 1 went down and is out of commission. I’ve
been able to assemble my array through mdadm using –assemble –scan. However
I cannot access the array due to the fact that the array cannot read a
filesystem. Everytime I try to mount I get mount: wrong fs type… etc. I know
that the FS is an ext3 FS. However I cannot seem to get this thing going. I
was wondering if anyone could point me in the right direction with this. I
can’t seem to find anyone that is capable of solving this. I would
appreciate any help. Thanks!

-Sunpyo

--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html