From: NeilBrown <neilb@suse.de>
To: linux-raid@vger.kernel.org
Subject: [md PATCH 34/36] md/raid10: simplify read error handling during recovery.
Date: Thu, 21 Jul 2011 12:58:50 +1000 [thread overview]
Message-ID: <20110721025850.8422.43827.stgit@notabene.brown> (raw)
In-Reply-To: <20110721024556.8422.99443.stgit@notabene.brown>
If a read error is detected during recovery the code currently
fails the read device.
This isn't really necessary. recovery_request_write will signal
a write error to end_sync_write and it will record a write
error on the destination device which will record a bad block
there or kick it from the array.
So just remove this call to do md_error.
Signed-off-by: NeilBrown <neilb@suse.de>
---
drivers/md/raid10.c | 9 ++++-----
1 files changed, 4 insertions(+), 5 deletions(-)
diff --git a/drivers/md/raid10.c b/drivers/md/raid10.c
index 0f120ac..f87c8d9 100644
--- a/drivers/md/raid10.c
+++ b/drivers/md/raid10.c
@@ -1418,13 +1418,12 @@ static void end_sync_read(struct bio *bio, int error)
if (test_bit(BIO_UPTODATE, &bio->bi_flags))
set_bit(R10BIO_Uptodate, &r10_bio->state);
- else {
+ else
+ /* The write handler will notice the lack of
+ * R10BIO_Uptodate and record any errors etc
+ */
atomic_add(r10_bio->sectors,
&conf->mirrors[d].rdev->corrected_errors);
- if (!test_bit(MD_RECOVERY_SYNC, &conf->mddev->recovery))
- md_error(r10_bio->mddev,
- conf->mirrors[d].rdev);
- }
/* for reconstruct, we always reschedule after a read.
* for resync, only after all reads
next prev parent reply other threads:[~2011-07-21 2:58 UTC|newest]
Thread overview: 65+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-07-21 2:58 [md PATCH 00/36] md patches for 3.1 - part 2: bad block logs NeilBrown
2011-07-21 2:58 ` [md PATCH 03/36] md: don't allow arrays to contain devices with bad blocks NeilBrown
2011-07-22 15:47 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 04/36] md: load/store badblock list from v1.x metadata NeilBrown
2011-07-22 16:34 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 02/36] md/bad-block-log: add sysfs interface for accessing bad-block-log NeilBrown
2011-07-22 15:43 ` Namhyung Kim
2011-07-26 2:29 ` NeilBrown
2011-07-26 5:17 ` Namhyung Kim
2011-07-26 8:48 ` Namhyung Kim
2011-07-26 15:03 ` [PATCH v2] md: add documentation for bad block log Namhyung Kim
2011-07-27 1:05 ` [md PATCH 02/36] md/bad-block-log: add sysfs interface for accessing bad-block-log NeilBrown
2011-07-21 2:58 ` [md PATCH 01/36] md: beginnings of bad block management NeilBrown
2011-07-22 15:03 ` Namhyung Kim
2011-07-26 2:26 ` NeilBrown
2011-07-26 5:17 ` Namhyung Kim
2011-07-22 16:52 ` Namhyung Kim
2011-07-26 3:20 ` NeilBrown
2011-07-21 2:58 ` [md PATCH 12/36] md/raid1: store behind-write pages in bi_vecs NeilBrown
2011-07-27 15:16 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 09/36] md: make it easier to wait for bad blocks to be acknowledged NeilBrown
2011-07-26 16:04 ` Namhyung Kim
2011-07-27 1:18 ` NeilBrown
2011-07-21 2:58 ` [md PATCH 10/36] md/raid1: avoid writing to known-bad blocks on known-bad drives NeilBrown
2011-07-27 4:09 ` Namhyung Kim
2011-07-27 4:19 ` NeilBrown
2011-07-21 2:58 ` [md PATCH 06/36] md/raid1: avoid reading from known bad blocks NeilBrown
2011-07-26 14:06 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 11/36] md/raid1: clear bad-block record when write succeeds NeilBrown
2011-07-27 5:05 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 14/36] md/raid1: record badblocks found during resync etc NeilBrown
2011-07-27 15:39 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 07/36] md/raid1: avoid reading known bad blocks during resync NeilBrown
2011-07-26 14:25 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 08/36] md: add 'write_error' flag to component devices NeilBrown
2011-07-26 15:22 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 13/36] md/raid1: Handle write errors by updating badblock log NeilBrown
2011-07-27 15:28 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 05/36] md: Disable bad blocks and v0.90 metadata NeilBrown
2011-07-22 17:02 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 20/36] md/raid5. Don't write to known bad block on doubtful devices NeilBrown
2011-07-21 2:58 ` [md PATCH 22/36] md/raid10: simplify/reindent some loops NeilBrown
2011-07-21 2:58 ` [md PATCH 18/36] md/raid5: use bad-block log to improve handling of uncorrectable read errors NeilBrown
2011-07-21 2:58 ` [md PATCH 17/36] md/raid5: avoid reading from known bad blocks NeilBrown
2011-07-21 2:58 ` [md PATCH 15/36] md/raid1: improve handling of read failure during recovery NeilBrown
2011-07-27 15:45 ` Namhyung Kim
2011-07-21 2:58 ` [md PATCH 21/36] md/raid5: Clear bad blocks on successful write NeilBrown
2011-07-21 2:58 ` [md PATCH 16/36] md/raid1: factor several functions out or raid1d() NeilBrown
2011-07-27 15:55 ` Namhyung Kim
2011-07-28 1:39 ` NeilBrown
2011-07-21 2:58 ` [md PATCH 24/36] md/raid10: avoid reading from known bad blocks - part 1 NeilBrown
2011-07-21 2:58 ` [md PATCH 23/36] md/raid10: Split handle_read_error out from raid10d NeilBrown
2011-07-21 2:58 ` [md PATCH 19/36] md/raid5: write errors should be recorded as bad blocks if possible NeilBrown
2011-07-21 2:58 ` NeilBrown [this message]
2011-07-21 2:58 ` [md PATCH 25/36] md/raid10: avoid reading from known bad blocks - part 2 NeilBrown
2011-07-21 2:58 ` [md PATCH 28/36] md/raid10 record bad blocks as needed during recovery NeilBrown
2011-07-21 2:58 ` [md PATCH 31/36] md/raid10: Handle write errors by updating badblock log NeilBrown
2011-07-21 2:58 ` [md PATCH 32/36] md/raid10: attempt to fix read errors during resync/check NeilBrown
2011-07-21 2:58 ` [md PATCH 26/36] md/raid10 - avoid reading from known bad blocks - part 3 NeilBrown
2011-07-21 2:58 ` [md PATCH 30/36] md/raid10: clear bad-block record when write succeeds NeilBrown
2011-07-21 2:58 ` [md PATCH 29/36] md/raid10: avoid writing to known bad blocks on known bad drives NeilBrown
2011-07-21 2:58 ` [md PATCH 33/36] md/raid10: record bad blocks due to write errors during resync/recovery NeilBrown
2011-07-21 2:58 ` [md PATCH 27/36] md/raid10: avoid reading known bad blocks " NeilBrown
2011-07-21 2:58 ` [md PATCH 35/36] md/raid10: Handle read errors during recovery better NeilBrown
2011-07-21 2:58 ` [md PATCH 36/36] md/raid10: handle further errors during fix_read_error better NeilBrown
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20110721025850.8422.43827.stgit@notabene.brown \
--to=neilb@suse.de \
--cc=linux-raid@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).