From: "yu kuai" <yukuai@fygo.io>
To: "Nilay Shroff" <nilay@linux.ibm.com>,
"Jens Axboe" <axboe@kernel.dk>, "Tejun Heo" <tj@kernel.org>,
"Josef Bacik" <josef@toxicpanda.com>,
"Johannes Weiner" <hannes@cmpxchg.org>,
"Michal Koutný" <mkoutny@suse.com>, "yu kuai" <yukuai@fygo.io>
Cc: "Christoph Hellwig" <hch@lst.de>, "Tao Cui" <cui.tao@linux.dev>,
"Jan Kara" <jack@suse.cz>, "Jonathan Corbet" <corbet@lwn.net>,
"Shuah Khan" <skhan@linuxfoundation.org>,
"Coly Li" <colyli@fygo.io>,
"Kent Overstreet" <kent.overstreet@linux.dev>,
"Alasdair Kergon" <agk@redhat.com>,
"Mike Snitzer" <snitzer@kernel.org>,
"Mikulas Patocka" <mpatocka@redhat.com>,
"Benjamin Marzinski" <bmarzins@redhat.com>,
"Song Liu" <song@kernel.org>,
"Li Nan" <magiclinan@didiglobal.com>,
"Xiao Ni" <xiao@kernel.org>,
"Pankaj Gupta" <pankaj.gupta.linux@gmail.com>,
"Dan Williams" <djbw@kernel.org>,
"Vishal Verma" <vishal.l.verma@intel.com>,
"Dave Jiang" <dave.jiang@intel.com>,
"Alison Schofield" <alison.schofield@intel.com>,
"Ira Weiny" <iweiny@kernel.org>,
"Andreas Gruenbacher" <agruenba@redhat.com>,
"Matthew Wilcox" <willy@infradead.org>,
"Andrew Morton" <akpm@linux-foundation.org>,
"Chris Li" <chrisl@kernel.org>,
"Kairui Song" <kasong@tencent.com>,
"Kemeng Shi" <shikemeng@huaweicloud.com>,
"Nhat Pham" <nphamcs@gmail.com>,
"Baoquan He" <baoquan.he@linux.dev>,
"Barry Song" <baohua@kernel.org>,
"Youngjun Park" <youngjun.park@lge.com>,
<cgroups@vger.kernel.org>, <linux-doc@vger.kernel.org>,
<linux-kernel@vger.kernel.org>, <linux-block@vger.kernel.org>,
<linux-bcache@vger.kernel.org>, <dm-devel@lists.linux.dev>,
<linux-raid@vger.kernel.org>, <nvdimm@lists.linux.dev>,
<virtualization@lists.linux.dev>, <gfs2@lists.linux.dev>,
<linux-fsdevel@vger.kernel.org>, <linux-mm@kvack.org>
Subject: Re: [PATCH 2/3] blk-cgroup: store blkcg in bio instead of blkg
Date: Sat, 12 Sep 2026 22:21:28 +0800 [thread overview]
Message-ID: <4701cbcb-b877-4902-a5b6-59836c345ae1@fygo.io> (raw)
In-Reply-To: <a123f309-6ec7-470f-b5b0-f08cca6d2627@linux.ibm.com>
Hi,
在 2026/9/7 14:02, Nilay Shroff 写道:
> On 9/6/26 5:09 PM, yu kuai wrote:
>> Hi,
>>
>> 在 2026/9/6 18:56, Nilay Shroff 写道:
>>> On 8/23/26 7:00 PM, Yu Kuai wrote:
>>>> @@ -257,20 +262,21 @@ static inline bool
>>>> bio_issue_as_root_blkg(struct bio *bio)
>>>> * @blkcg: blkcg of interest
>>>> * @q: request_queue of interest
>>>> *
>>>> * Lookup a blkg for the @blkcg - @q pair, whether it is online or
>>>> dying.
>>>> *
>>>> - * Must be called in a RCU critical section.
>>>> + * Must be called with either RCU read lock or queue_lock held.
>>>> *
>>>> * This does not acquire a reference. The caller must already hold
>>>> one, or
>>>> * have the blkg pinned by I/O.
>>>> */
>>>> static inline struct blkcg_gq *blkg_lookup_any(struct blkcg *blkcg,
>>>> struct request_queue *q)
>>>> {
>>>> - RCU_LOCKDEP_WARN(!rcu_read_lock_held(),
>>>> - "blkg_lookup_any() requires an RCU read lock");
>>>> + RCU_LOCKDEP_WARN(!rcu_read_lock_held() &&
>>>> + !lockdep_is_held(&q->queue_lock),
>>>> + "blkg_lookup_any() requires an RCU read lock or
>>>> queue_lock");
>>>> return rhashtable_lookup(&q->blkg_hash, &blkcg->css.id,
>>>> blkg_hash_params);
>>>> }
>>>
>>> The changes look good to me. However, rhashtable_lookup() is annotated
>>> with __must_hold_shared(RCU). Since we now officially support Clang
>>> context annotations in the block layer, compiling with the latest
>>> Clang/LLVM generates a number of context warnings, for example:
>>>
>>> block/blk-cgroup.h:277:9: warning: calling function 'rhashtable_lookup'
>>> requires holding __ctx_lock_RCU 'RCU' [-Wthread-safety-analysis]
>>> 277 | return rhashtable_lookup(&q->blkg_hash,
>>> &blkcg->css.id,
>>> | ^
>>>
>>> The same warning is reported from several other block layer source
>>> files that include blk-cgroup.h.
>>>
>>> This indicates that rhashtable_lookup() requires the RCU read lock
>>> from Clang's context-analysis perspective. Looking at the call paths of
>>> blkg_lookup_any(), it appears that not all callers hold
>>> rcu_read_lock() when invoking it.
>>
>> I was not aware of the above clang warning, this should not be a real
>> problem
>> because queue_lock should have the same protection as rcu, and I was
>> trying
>> not to make this patch too complex.
>>
> I agree that this is not a runtime correctness issue when the lookup
> is already
> protected by q->queue_lock.
>
>> I add the rcu_read_lock() in the following patch to covert queue_lock
>> to blkcg_mutex:
>>
>> [RFC PATCH v3 3/6] blk-cgroup: protect blkgs with blkcg_mutex - Yu
>> Kuai
>> <https://lore.kernel.org/all/20260823152926.1043863-4-yukuai@kernel.org/>
>>
>> Since this is related to compile warning, I'll move the rcu
>> protection to this
>> patch.
>>
> Since rhashtable_lookup() is annotated with __must_hold_shared(RCU),
> Clang's
> context analysis still reports warnings for these call paths. While this
> doesn't cause a build failure (and only generates warning) when
> CONFIG_WERROR
> is not enabled, it could do so for configurations that enable
> CONFIG_WERROR=y.
>
> So IMO, moving the rcu_read_lock() protection into this patch makes
> sense.
> This would avoid introducing the Clang warnings/errors in this patch,
> and then
> you may accordingly adjust your subsequent series where the
> q->queue_lock protection
> is removed and the blkg lookup paths are protected by RCU.
>
> I also noticed that some paths already take q->queue_lock followed by
> rcu_read_lock(),
> so adding the RCU protection here should be consistent with those
> existing paths.
Turns out Clang will still warn after adding rcu_read_lock(). I'm not familiar how this
works, but AI told me this is related to inline helpers, And I'll have to add the same
__must_hold_shared(RCU) in rhashtable_lookup() for following inline callers to kill the
warning:
static inline struct blkcg_gq *blkg_lookup_any(...)
__must_hold_shared(RCU);
static inline struct blkcg_gq *blkg_lookup(...)
__must_hold_shared(RCU);
>
> Thanks,
> --Nilay
--
Thanks,
Kuai
next prev parent reply other threads:[~2026-09-12 14:21 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-08-23 13:30 [PATCH 0/3] blk-cgroup: store blkcg in bio before blkcg_mutex conversion Yu Kuai
2026-08-23 13:30 ` [PATCH 1/3] blk-cgroup: use a request_queue rhashtable for blkg lookup Yu Kuai
2026-09-06 11:03 ` Nilay Shroff
2026-08-23 13:30 ` [PATCH 2/3] blk-cgroup: store blkcg in bio instead of blkg Yu Kuai
2026-09-02 13:49 ` Christoph Hellwig
2026-09-06 10:56 ` Nilay Shroff
2026-09-06 11:39 ` yu kuai
2026-09-07 6:02 ` Nilay Shroff
2026-09-12 14:21 ` yu kuai [this message]
2026-09-13 13:02 ` Nilay Shroff
2026-08-23 13:30 ` [PATCH 3/3] blk-cgroup: move async bio punt state to blkcg Yu Kuai
2026-09-02 13:49 ` Christoph Hellwig
2026-09-06 11:01 ` Nilay Shroff
2026-09-06 11:41 ` yu kuai
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4701cbcb-b877-4902-a5b6-59836c345ae1@fygo.io \
--to=yukuai@fygo.io \
--cc=agk@redhat.com \
--cc=agruenba@redhat.com \
--cc=akpm@linux-foundation.org \
--cc=alison.schofield@intel.com \
--cc=axboe@kernel.dk \
--cc=baohua@kernel.org \
--cc=baoquan.he@linux.dev \
--cc=bmarzins@redhat.com \
--cc=cgroups@vger.kernel.org \
--cc=chrisl@kernel.org \
--cc=colyli@fygo.io \
--cc=corbet@lwn.net \
--cc=cui.tao@linux.dev \
--cc=dave.jiang@intel.com \
--cc=djbw@kernel.org \
--cc=dm-devel@lists.linux.dev \
--cc=gfs2@lists.linux.dev \
--cc=hannes@cmpxchg.org \
--cc=hch@lst.de \
--cc=iweiny@kernel.org \
--cc=jack@suse.cz \
--cc=josef@toxicpanda.com \
--cc=kasong@tencent.com \
--cc=kent.overstreet@linux.dev \
--cc=linux-bcache@vger.kernel.org \
--cc=linux-block@vger.kernel.org \
--cc=linux-doc@vger.kernel.org \
--cc=linux-fsdevel@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mm@kvack.org \
--cc=linux-raid@vger.kernel.org \
--cc=magiclinan@didiglobal.com \
--cc=mkoutny@suse.com \
--cc=mpatocka@redhat.com \
--cc=nilay@linux.ibm.com \
--cc=nphamcs@gmail.com \
--cc=nvdimm@lists.linux.dev \
--cc=pankaj.gupta.linux@gmail.com \
--cc=shikemeng@huaweicloud.com \
--cc=skhan@linuxfoundation.org \
--cc=snitzer@kernel.org \
--cc=song@kernel.org \
--cc=tj@kernel.org \
--cc=virtualization@lists.linux.dev \
--cc=vishal.l.verma@intel.com \
--cc=willy@infradead.org \
--cc=xiao@kernel.org \
--cc=youngjun.park@lge.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox