Re: Western Digital RE3: Raid Failure

[Zdenek Kaspar <zkaspar82@gmail.com>]

MOgWai46[Saurceful of Secrets] napsal(a):
> 2009/8/31 Zdenek Kaspar <zkaspar82@gmail.com>:
> 
>> Do you have some sort of port multiplier [because it looks like there
>> are 2 devices on ata2 -> ata2.00 (sdc),ata2.01 (sdd?)] and can you
>> provide smartctl -a /dev/sdc output ?
> 
> This is the output of smartctl -a /dev/sdc: http://nopaste.com/p/aXwmnSEphb
> 
> This is the output of smartctl -a /dev/sdd: http://nopaste.com/p/aYzhpzppv
> 
> There isn't any port replicator on this little server (is not a
> critical or production server). It has 4 SATA Port on the Mainboard:
> 
> # lspci -v
> 
> 00:1f.2 IDE interface: Intel Corporation 82801GB/GR/GH (ICH7 Family)
> SATA IDE Controller (rev 01) (prog-if 8a [Master SecP PriP])
>         Subsystem: Hewlett-Packard Company Unknown device 3206
>         Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 233
>         I/O ports at <unassigned>
>         I/O ports at <unassigned>
>         I/O ports at <unassigned>
>         I/O ports at <unassigned>
>         I/O ports at 3080 [size=16]
>         Memory at 88000000 (32-bit, non-prefetchable) [size=1K]
>         Capabilities: [70] Power Management version 2
> 
> Thanks, Andrea


As others already pointed to Reallocated_Sector_Ct value.. it's bad sign
and you should replace (RMA) such drive quickly. BTW, speed is
significantly degraded when disk works with sectors from remapped area.

HTH, Z.