From mboxrd@z Thu Jan 1 00:00:00 1970 From: =?UTF-8?B?VMOzdGggQ3NhYmE=?= Subject: Re: convert raid10 to raid0 Date: Thu, 08 Jul 2010 09:58:38 +0200 Message-ID: <4C35852E.5060400@i3rendszerhaz.hu> References: <4C34D5AD.5020305@i3rendszerhaz.hu> <20100708085034.2bc8272e@notabene.brown> Mime-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: QUOTED-PRINTABLE Return-path: In-Reply-To: <20100708085034.2bc8272e@notabene.brown> Sender: linux-raid-owner@vger.kernel.org To: Neil Brown Cc: linux-raid@vger.kernel.org List-Id: linux-raid.ids 2010.07.08. 0:50 keltez=C3=A9ssel, Neil Brown =C3=ADrta: > Then after you create the raid0, use the same command > mdadm -E /dev/sdc6 > to check the Data Offset again and make sure it is the same. > I suspect it will be, so everything will be fine. > However if it isn't don't try to access the array. Post the details= and I'll > figure out what to do next. >=20 It doesn't work, and the data offsets are different (in the mean time i figured out that i made a mistake, and not sdc6 but sdb6 is the other correct device): Old: sdb6: 592 sectors sdd6: 264 sectors New: sdb6: 2048 sectors sdd6: 2048 sectors if i modify the source code of the mdadm, but don't know how to make it to set differently based on the partition.. thanks in advance! Csaba -- To unsubscribe from this list: send the line "unsubscribe linux-raid" i= n the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html