From: Simon McNair <simonmcnair@gmail.com>
To: Phil Turmel <philip@turmel.org>
Cc: NeilBrown <neilb@suse.de>, linux-raid@vger.kernel.org
Subject: Re: Linux software RAID assistance
Date: Wed, 16 Feb 2011 18:52:40 +0000 [thread overview]
Message-ID: <4D5C1CF8.1020507@gmail.com> (raw)
In-Reply-To: <4D5C167C.7000101@turmel.org>
have done this.... Results are:
proxmox:/home/simon# ./lsdrv.sh
Controller device @ pci0000:00/0000:00:01.0/0000:01:00.0 [mvsas]
SCSI storage controller: Marvell Technology Group Ltd.
MV64460/64461/64462 System Controller, Revision B (rev 01)
host0: /dev/sdf ATA Hitachi HDS72101 {SN: GTA000PAGABXRA}
host0: /dev/sdg ATA Hitachi HDS72101 {SN: GTA000PAGAA5DA}
host0: /dev/sdh ATA Hitachi HDS72101 {SN: GTA000PAG9NL9A}
host0: /dev/sdi ATA Hitachi HDS72101 {SN: GTA000PAGA8V4A}
host0: /dev/sdj ATA Hitachi HDS72101 {SN: GTD000PAGMT9GD}
host0: /dev/sdk ATA Hitachi HDS72101 {SN: GTG000PAG18BJC}
host0: /dev/sdl ATA Hitachi HDS72101 {SN: GTG000PAG1DPLC}
host0: /dev/sdm ATA Hitachi HDS72101 {SN: GTA000PAG7WMEA}
Controller device @
pci0000:00/0000:00:1a.7/usb1/1-4/1-4.1/1-4.1.1/1-4.1.1:1.0 [usb-storage]
Bus 001 Device 007: ID 0424:2228 Standard Microsystems Corp. 9-in-2
Card Reader {SN: 08050920003A}
host11: /dev/sdb Generic Flash HS-CF
host11: /dev/sdc Generic Flash HS-COMBO
Controller device @ pci0000:00/0000:00:1c.4/0000:04:00.0 [ahci]
SATA controller: JMicron Technology Corp. JMB362/JMB363 Serial ATA
Controller (rev 03)
host9: [Empty]
host10: [Empty]
Controller device @ pci0000:00/0000:00:1c.4/0000:04:00.1 [pata_jmicron]
IDE interface: JMicron Technology Corp. JMB362/JMB363 Serial ATA
Controller (rev 03)
host1: [Empty]
host2: [Empty]
Controller device @ pci0000:00/0000:00:1f.2 [ahci]
SATA controller: Intel Corporation 82801JI (ICH10 Family) SATA AHCI
Controller
host3: /dev/sda ATA STM3500418AS {SN: 9VM3QJ5C}
host4: /dev/sr0 Optiarc DVD RW AD-5240S
host5: [Empty]
host6: [Empty]
host7: /dev/sdd ATA Hitachi HDS72101 {SN: GTD000PAGMT8DD}
host8: /dev/sde ATA Hitachi HDS72101 {SN: GTG000PAG04V0C}
enabling achi has switched the drive letters around for a couple of
drives again
parted list is:
proxmox:/home/simon# for x in /dev/sd{i,h,g,f,m,l,k,j,d,e} ; do parted
-s $x unit s print ; done
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdi: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdh: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdg: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdf: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdm: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdl: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdk: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdj: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sdd: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
Model: ATA Hitachi HDS72101 (scsi)
Disk /dev/sde: 1953525168s
Sector size (logical/physical): 512B/512B
Partition Table: gpt
Number Start End Size File system Name Flags
1 2048s 1953101823s 1953099776s primary raid
is it now:
mdadm --create --verbose --assume-clean /dev/md0 --metadata=1.1
--level=5 --raid-devices=10 /dev/sd{i,h,g,f,m,l,k,j,d,e}1 --chunk=64
?
regards
Simon
On 16/02/2011 18:25, Phil Turmel wrote:
> On 02/16/2011 01:22 PM, Phil Turmel wrote:
>> On 02/16/2011 01:18 PM, Simon McNair wrote:
>>> parted -l gives
>>>
>>> Error: The backup GPT table is not at the end of the disk, as it should be. This might mean that another operating
>>> system believes the disk is smaller. Fix, by moving the backup to the end (and removing the old backup)?
>>> Fix/Cancel? fix
>>> Warning: Not all of the space available to /dev/sdb appears to be used, you can fix the GPT to use all of the space (an
>>> extra 421296 blocks) or continue with the current setting?
>>> Fix/Ignore?
>>>
>>> I'm guessing ignore ?
>> Either should work. If you 'Fix' for all of the drives, you could later 'grow' your array to include the extra space.
> It's vital that the start sector be 2048, though. Please do recheck after all are done.
>
> Phil
next prev parent reply other threads:[~2011-02-16 18:52 UTC|newest]
Thread overview: 64+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-02-10 16:16 Linux software RAID assistance Simon McNair
2011-02-10 18:24 ` Phil Turmel
2011-02-15 4:53 ` NeilBrown
2011-02-15 8:48 ` Simon McNair
2011-02-15 14:51 ` Phil Turmel
2011-02-15 19:04 ` Simon McNair
2011-02-15 19:37 ` Phil Turmel
2011-02-15 19:45 ` Roman Mamedov
2011-02-15 21:09 ` Simon McNair
2011-02-17 15:10 ` Simon Mcnair
2011-02-17 15:42 ` Roman Mamedov
2011-02-18 9:13 ` Simon McNair
2011-02-18 9:38 ` Robin Hill
2011-02-18 10:38 ` Simon Mcnair
2011-02-19 11:46 ` Jan Ceuleers
2011-02-19 12:40 ` Simon McNair
2011-02-19 17:37 ` Jan Ceuleers
2011-02-16 13:51 ` Simon McNair
2011-02-16 14:37 ` Phil Turmel
2011-02-16 17:49 ` Simon McNair
2011-02-16 18:14 ` Phil Turmel
2011-02-16 18:18 ` Simon McNair
2011-02-16 18:22 ` Phil Turmel
2011-02-16 18:25 ` Phil Turmel
2011-02-16 18:52 ` Simon McNair [this message]
2011-02-16 18:57 ` Phil Turmel
2011-02-16 19:07 ` Simon McNair
2011-02-16 19:10 ` Phil Turmel
2011-02-16 19:15 ` Simon McNair
2011-02-16 19:36 ` Phil Turmel
2011-02-16 21:28 ` Simon McNair
2011-02-16 21:30 ` Phil Turmel
2011-02-16 22:44 ` Simon Mcnair
2011-02-16 23:39 ` Phil Turmel
2011-02-17 13:26 ` Simon Mcnair
2011-02-17 13:48 ` Phil Turmel
2011-02-17 13:56 ` Simon Mcnair
2011-02-17 14:34 ` Simon Mcnair
2011-02-17 16:54 ` Phil Turmel
2011-02-19 8:43 ` Simon Mcnair
2011-02-19 15:30 ` Phil Turmel
[not found] ` <AANLkTinOXJWRw_et2U43R_T9XPBzQLnN56Kf2bOAz=_c@mail.gmail.com>
2011-02-19 16:19 ` Phil Turmel
2011-02-20 9:56 ` Simon Mcnair
2011-02-20 19:50 ` Phil Turmel
2011-02-20 23:17 ` Simon Mcnair
2011-02-20 23:39 ` Phil Turmel
2011-02-22 17:12 ` Simon Mcnair
2011-02-22 17:14 ` Simon Mcnair
2011-02-22 18:23 ` Phil Turmel
2011-02-22 18:36 ` Simon McNair
2011-02-22 19:06 ` Phil Turmel
2011-02-18 9:31 ` Simon Mcnair
2011-02-18 13:16 ` Phil Turmel
2011-02-18 13:21 ` Roberto Spadim
2011-02-18 13:26 ` Phil Turmel
2011-02-18 13:29 ` Simon Mcnair
2011-02-18 13:34 ` Phil Turmel
2011-02-18 14:12 ` Simon McNair
2011-02-18 16:10 ` Phil Turmel
2011-02-18 16:38 ` Roberto Spadim
[not found] ` <AANLkTi=RmR5nVnmFLuqK5anHc3WDPxjuYjitT6+5wAqS@mail.gmail.com>
2011-02-20 18:48 ` Phil Turmel
2011-02-20 19:25 ` Simon Mcnair
2011-02-19 8:49 ` Simon Mcnair
2011-02-16 13:56 ` Simon McNair
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4D5C1CF8.1020507@gmail.com \
--to=simonmcnair@gmail.com \
--cc=linux-raid@vger.kernel.org \
--cc=neilb@suse.de \
--cc=philip@turmel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).