Hi!

After I rebooted during a raid6 rebuild, the rebuild didn't start again.
Instead, there is a flood of "RAID conf printout"s that seemingly happen
on array activity.

All the devices show up properly in --detail and two devices are marked
as "spare rebuilding", and I can access the contents of the array just
fine, but the rebuild doesn't actually start. Is this a bug or am I
missing something? :)

I was initially on 2.6.38.8, but also tried 3.1.4 which seems to have
the same issue. mdadm is 3.1.5.

I'm not using start_ro and writing to the array doesn't trigger a
rebuild either.

Attached are --examine outputs before assembly, kernel log output on
assembly, /proc/mdstat and --detail after assembly (on 3.1.4).

-- 
Anssi Hannula