From: Danilo Godec <danilo.godec@agenda.si>
To: linux-raid@vger.kernel.org
Subject: Raid failure - drives or controller?
Date: Wed, 07 Mar 2012 18:52:30 +0100 [thread overview]
Message-ID: <4F57A05E.6000204@agenda.si> (raw)
Hi,
I had two drive failure on a RAID5 in short time (unfortunately to short
to rebuild on a spare disk). However - drives seem to work on a test
machine and didn't report any errors. I also stuck them back into the
orig. server (after rebooting) and they work now.
The first drive's errors were:
> Mar 6 05:15:19 san1 kernel: [10681162.473960] sd 4:0:3:0: [sde]
> Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
> Mar 6 05:15:19 san1 kernel: [10681162.473965] sd 4:0:3:0: [sde] Sense
> Key : Aborted Command [current]
> Mar 6 05:15:19 san1 kernel: [10681162.473969] sd 4:0:3:0: [sde] Add.
> Sense: No additional sense information
> Mar 6 05:15:19 san1 kernel: [10681162.473973] sd 4:0:3:0: [sde] CDB:
> Read(10): 28 00 07 af 38 3f 00 00 08 00
> Mar 6 05:15:19 san1 kernel: [10681162.473980] end_request: I/O error,
> dev sde, sector 128923711
> Mar 6 05:17:53 san1 kernel: [10681316.885221] sd 4:0:3:0: [sde]
> Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
> Mar 6 05:17:53 san1 kernel: [10681316.885225] sd 4:0:3:0: [sde] Sense
> Key : Illegal Request [current]
> Mar 6 05:17:53 san1 kernel: [10681316.885229] sd 4:0:3:0: [sde] Add.
> Sense: Logical block address out of range
> Mar 6 05:17:53 san1 kernel: [10681316.885234] sd 4:0:3:0: [sde] CDB:
> Write(10): 2a 08 74 70 58 c7 00 00 08 00
> Mar 6 05:17:53 san1 kernel: [10681316.885242] end_request: I/O error,
> dev sde, sector 1953519815
> Mar 6 05:17:53 san1 kernel: [10681316.885246] end_request: I/O error,
> dev sde, sector 1953519815
> Mar 6 05:17:53 san1 kernel: [10681316.885252] raid5: Disk failure on
> sde1, disabling device.
> Mar 6 05:20:27 san1 kernel: [10681470.600610] sd 4:0:3:0: [sde]
> Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
> Mar 6 05:20:27 san1 kernel: [10681470.600615] sd 4:0:3:0: [sde] Sense
> Key : Illegal Request [current]
> Mar 6 05:20:27 san1 kernel: [10681470.600619] sd 4:0:3:0: [sde] Add.
> Sense: Logical block address out of range
> Mar 6 05:20:27 san1 kernel: [10681470.600624] sd 4:0:3:0: [sde] CDB:
> Write(10): 2a 08 74 70 59 27 00 00 08 00
> Mar 6 05:20:27 san1 kernel: [10681470.600631] end_request: I/O error,
> dev sde, sector 1953519911
> Mar 6 05:20:27 san1 kernel: [10681470.600636] end_request: I/O error,
> dev sde, sector 1953519911
> Mar 6 05:20:28 san1 kernel: [10681471.664682] disk 3, o:0, dev:sde1
> Mar 6 05:21:47 san1 kernel: [10681549.746852] sd 4:0:3:0: [sde]
> Synchronizing SCSI cache
> Mar 6 05:21:47 san1 kernel: [10681549.746905] sd 4:0:3:0: [sde]
> Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
The second drive did this:
> Mar 7 02:31:37 san1 kernel: [10757598.197391] sd 4:0:5:0: [sdg]
> Result: hostbyte=DID_OK driverbyte=DRIVER_SENSE
> Mar 7 02:31:37 san1 kernel: [10757598.197396] sd 4:0:5:0: [sdg] Sense
> Key : Aborted Command [current]
> Mar 7 02:31:37 san1 kernel: [10757598.197400] sd 4:0:5:0: [sdg] Add.
> Sense: No additional sense information
> Mar 7 02:31:37 san1 kernel: [10757598.197404] sd 4:0:5:0: [sdg] CDB:
> Read(10): 28 00 07 12 05 9f 00 00 10 00
> Mar 7 02:31:37 san1 kernel: [10757598.197411] end_request: I/O error,
> dev sdg, sector 118621599
> Mar 7 02:31:37 san1 kernel: [10757598.583990] raid5: Disk failure on
> sdg1, disabling device.
> Mar 7 02:31:37 san1 kernel: [10757598.616232] disk 5, o:0, dev:sdg1
Can anyone make some actual sense out of these sense messages?
Are these drives really / likely bad or is it more likely it was a
controller failure?
D.
--
Danilo Godec, sistemska podpora / system administration
Predlog! Obiscite prenovljeno spletno stran www.agenda.si
ODPRTA KODA IN LINUX
STORITVE : POSLOVNE RESITVE : UPRAVLJANJE IT : INFRASTRUKTURA IT : IZOBRAZEVANJE : PROGRAMSKA OPREMA
Visit our updated web page at www.agenda.si
OPEN SOURCE AND LINUX
SERVICES : BUSINESS SOLUTIONS : IT MANAGEMENT : IT INFRASTRUCTURE : TRAINING : SOFTWARE
next reply other threads:[~2012-03-07 17:52 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-03-07 17:52 Danilo Godec [this message]
2012-03-07 19:33 ` Raid failure - drives or controller? Ray Morris
2012-03-07 21:08 ` Danilo Godec
2012-03-07 21:11 ` Mathias Burén
2012-03-07 21:15 ` Danilo Godec
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4F57A05E.6000204@agenda.si \
--to=danilo.godec@agenda.si \
--cc=linux-raid@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox