From mboxrd@z Thu Jan 1 00:00:00 1970 From: Carlos Mennens Subject: Re: RAID Configuration For New Home Server Date: Wed, 2 Jun 2010 09:00:04 -0400 Message-ID: References: Mime-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Return-path: In-Reply-To: Sender: linux-raid-owner@vger.kernel.org To: Mdadm List-Id: linux-raid.ids On Wed, Jun 2, 2010 at 3:54 AM, wrote: > There are about as many answers to this as there are people using your > setup so let's all agree that there's no "one way" of doing things. Thanks for all the suggestions and you guys are right. There will no right or wrong answer here but I just want to make sure I am not doing anything that will hinder / limit performance in my system. At most my system will simply idle and do nothing more than store a few files for me so I think RAID5 is going to be my selection for my / file system. I have 4 identical drives and need to partition them all the same to avoid any inconsistencies across the RAID array. Since Grub doesn't support RAID5 for /boot, I will need to make a 4 disk RAID1 for /boot & do the same for Swap. Does this look reasonable to you guys? Partitioning the 1st disk below: /dev/sda1 100 MB - RAID (bootable) /dev/sda2 2 GB - RAID /dev/sda3 320 GB - RAID Do that same partition schema above for all 4 drives and then create my RAID: / mdadm --create /dev/md0 --level=5 --raid-devices=4 /dev/sda3 /dev/sdb3 /dev/sdc3 /dev/sdd3 /boot mdadm --create /dev/md1 --level=1 --raid-devices=4 /dev/sda1 /dev/sdb1 /dev/sdc1 /dev/sdd1 Swap mdadm --create /dev/md2 --level=1 --raid-devices=4 /dev/sda2 /dev/sdb2 /dev/sdc2 /dev/sdd2 Would you guys change anything in my partition or 'mdadm' command?