* RE: 6-drive RAID 10 failed, cannot reactivate, need help
2011-05-02 18:17 6-drive RAID 10 failed, cannot reactivate, need help fibreraid
@ 2011-05-06 21:40 ` Leslie Rhorer
0 siblings, 0 replies; 2+ messages in thread
From: Leslie Rhorer @ 2011-05-06 21:40 UTC (permalink / raw)
To: fibreraid, 'linux-raid'
> -----Original Message-----
> From: linux-raid-owner@vger.kernel.org [mailto:linux-raid-
> owner@vger.kernel.org] On Behalf Of fibreraid@gmail.com
> Sent: Monday, May 02, 2011 1:17 PM
> To: linux-raid
> Subject: 6-drive RAID 10 failed, cannot reactivate, need help
>
> Hi All,
>
> I have an Ubuntu Hardy 64-bit system with mdadm 2.6.9.
>
> I have a 6-drive RAID 10 named md1. Unfortunately, there was some
> power outage and when the system came back up, it showed 2 drives as
> failed and 4 as active. I removed the two failed drives from the array
> using -r, and then added them back in using --add and --force. The
Ooh, that's bad.
> array will not rebuild though. It simply shows now these two drives as
> spares.
>
> I doubt the data is actually lost since it was a sudden outage. What
> can I do from here to get mdadm to activate this array and kick off
> rebuild if needed? I'm really stuck. Thanks in advance for any help.
First of all, I heartily suggest you copy at least the failed drives
and if possible all 6 drives to spare hard drives using dd_rescue. After
that, you are going to need to re-create the array. Make sure all the
parameters are the same as the original, including superb;ock, chunk size,
bitmap, and position within the array. Essentially, allowing for any
differences in drive position and any growth or re-shaping of the array, you
need to re-issue the same command originally issued to create the array,
except use the --assume-clean switch so md won't try to re-sync. Mount the
file system ready-only and attempt to read it. If it fails, stop the array,
determine which element is incorrect, and try again.
^ permalink raw reply [flat|nested] 2+ messages in thread