Linux Renesas SOC kernel development
 help / color / mirror / Atom feed
 messages from 2019-03-07 09:13:01 to 2019-03-13 00:05:58 UTC [more...]

[PATCH v6 00/18] R-Car DU display writeback support
 2019-03-13  0:05 UTC  (11+ messages)
` [PATCH v6 01/18] Revert "[media] v4l: vsp1: Supply frames to the DU continuously"
` [PATCH v6 02/18] media: vsp1: wpf: Fix partition configuration for display pipelines
` [PATCH v6 03/18] media: vsp1: Replace leftover occurrence of fragment with body
` [PATCH v6 04/18] media: vsp1: Fix addresses of display-related registers for VSP-DL
` [PATCH v6 05/18] media: vsp1: Replace the display list internal flag with a flags field
` [PATCH v6 06/18] media: vsp1: Add vsp1_dl_list argument to .configure_stream() operation
` [PATCH v6 07/18] media: vsp1: dl: Allow chained display lists for display pipelines
` [PATCH v6 08/18] media: vsp1: wpf: Add writeback support
` [PATCH v6 09/18] media: vsp1: drm: Split RPF format setting to separate function
` [PATCH v6 12/18] drm: writeback: Cleanup job ownership handling when queuing job

[PATCH v3 0/3] rcar-csi2: Update start procedures to latest revision of datasheet
 2019-03-12 23:50 UTC  (4+ messages)
` [PATCH v3 1/3] rcar-csi2: Update V3M and E3 start procedure
` [PATCH v3 2/3] rcar-csi2: Update start procedure for H3 ES2
` [PATCH v3 3/3] rcar-csi2: Move setting of Field Detection Control Register

[PATCH v3] rcar-csi2: Propagate the FLD signal for NTSC and PAL
 2019-03-12 23:49 UTC 

[PATCH v3 0/2] rcar-csi2: Use standby mode instead of resetting
 2019-03-12 23:49 UTC  (3+ messages)
` [PATCH v3 1/2] dt-bindings: rcar-csi2: List resets as a mandatory property
` [PATCH v3 2/2] rcar-csi2: Use standby mode instead of resetting

[PATCH] drm: rcar-du: lvds: Fix post-DLL divider calculation
 2019-03-12 23:18 UTC 

[PATCH v2] net: renesas: fix a missing check of of_get_phy_mode
 2019-03-12 21:51 UTC  (12+ messages)
      ` [PATCH v2] net: sh_eth: "
          ` [PATCH v3] "

[PATCH] rcar-csi2: restart CSI-2 link if error is detected
 2019-03-12 21:37 UTC  (5+ messages)

[PATCH v2 0/2] rcar-csi2: Use standby mode instead of resetting
 2019-03-12 20:23 UTC  (8+ messages)
` [PATCH v2 1/2] dt-bindings: rcar-csi2: List resets as a mandatory property
` [PATCH v2 2/2] rcar-csi2: Use standby mode instead of resetting

[PATCH 27/42] drivers: gpio: rcar: use devm_platform_ioremap_resource()
 2019-03-12 19:03 UTC  (2+ messages)
  ` [PATCH 26/42] drivers: gpio: rcar: pendantic formatting

[PATCH v2 0/3] rcar-csi2: Update start procedures to latest revision of datasheet
 2019-03-12 18:47 UTC  (9+ messages)
` [PATCH v2 1/3] rcar-csi2: Update V3M and E3 start procedure
` [PATCH v2 2/3] rcar-csi2: Update start procedure for H3 ES2
` [PATCH v2 3/3] rcar-csi2: Move setting of Field Detection Control Register

[PATCH] spi: rspi: Fix sequencer reset during initialization
 2019-03-12 18:45 UTC 

[PATCH] spi: rspi: Fix register initialization while runtime-suspended
 2019-03-12 18:43 UTC 

[PATCH v2] gpu: drm: atomic_helper: Fix spelling errors
 2019-03-12 15:59 UTC  (3+ messages)

[PATCH i2c-tools 0/2] tools: improvements to handling restricted addresses
 2019-03-12 15:50 UTC  (4+ messages)
` [PATCH i2c-tools 1/2] tools: i2ctransfer: consequently document -a
` [PATCH i2c-tools 2/2] tools: restrict all addresses defined by the standard

[RFC PATCH v2 0/7] i2c: core: introduce atomic transfers
 2019-03-12 15:45 UTC  (3+ messages)

[PATCH 0/3] i2c: rcar: make DMA more robust
 2019-03-12 13:56 UTC  (15+ messages)
` [PATCH 1/3] i2c: rcar: sanity check for minimal DMA length
` [PATCH 2/3] i2c: rcar: let DMA enable routine return success status
` [PATCH 3/3] i2c: rcar: wait for data empty before starting DMA

[PATCH v2] i2c: add extra check to safe DMA buffer helper
 2019-03-12 12:57 UTC  (2+ messages)

[PATCH] pwm: Avoid deadlock warning when removing PWM device
 2019-03-12 12:45 UTC  (9+ messages)

[PATCH] i2c: add extra check to safe DMA buffer helper
 2019-03-12 12:11 UTC  (5+ messages)

[PATCH 2/2] mtd: spi-nor: refine Spansion S25FL512S ID
 2019-03-12 11:02 UTC  (2+ messages)

[PATCH] net: ravb_main: fix a missing check of of_get_phy_mode
 2019-03-12  7:42 UTC  (3+ messages)

[PATCH v2] rcar-csi2: Propagate the FLD signal for NTSC and PAL
 2019-03-12  0:35 UTC  (5+ messages)

[PATCH v3 0/4] Renesas R8A77980 CPG/MSSR RPC clock support
 2019-03-11 19:10 UTC  (5+ messages)
` [PATCH] clk: renesas: r8a77980-cpg-mssr: fix RPC-IF module clock's parent

[PATCH] media: adv748x: Don't disable CSI-2 on link_setup
 2019-03-11 14:32 UTC  (8+ messages)

[PATCH] arm64: dts: renesas: r8a77995: draak: Enable CAN0, CAN1
 2019-03-11 13:38 UTC  (3+ messages)

[PATCH] net: renesas: fix a potential NULL pointer dereference
 2019-03-11 10:43 UTC  (3+ messages)

[PATCH V2] PCI: rcar: Add the initialization of PCIe link in resume_noirq
 2019-03-11 10:10 UTC  (6+ messages)

[PATCH] arm64: dts: renesas: r8a774c0: Remove invalid compatible value for CSI40
 2019-03-11 10:01 UTC  (2+ messages)

[PATCH 1/2] PCI: rcar: Clean up remaining macros defining bits
 2019-03-11  9:41 UTC  (6+ messages)
` [PATCH 2/2] PCI: rcar: Replace unsigned long with u32 in register accessors

[PATCH/RFC 00/15] R-Car DU: LVDS dual-link mode support
 2019-03-09 11:51 UTC  (21+ messages)
` [PATCH/RFC 05/15] dt-bindings: display: bridge: thc63lvd1024: Document dual-link operation
` [PATCH/RFC 06/15] drm: bridge: thc63: Report input bus mode through bridge timings
` [PATCH/RFC 09/15] drm: rcar-du: lvds: Adjust operating frequency for D3 and E3
` [PATCH/RFC 10/15] drm: rcar-du: lvds: Set LVEN and LVRES bits together on D3
` [PATCH/RFC 11/15] drm: rcar-du: lvds: Add support for dual-link mode

[PATCH] media: rcar-vin: fix a potential NULL pointer dereference
 2019-03-09 11:02 UTC  (2+ messages)

[PATCH 0/2] i2c: rcar: improve concurrency
 2019-03-09 10:11 UTC  (5+ messages)
` [PATCH 1/2] i2c: rcar: fix concurrency issue related to ICDMAER
` [PATCH 2/2] i2c: rcar: explain the lockless design

[PATCH] media: renesas-ceu: fix a potential NULL pointer dereference
 2019-03-09  9:58 UTC  (2+ messages)

[PATCH 1/2] [RFC] ata: ahci: Respect bus DMA constraints
 2019-03-08 23:23 UTC  (7+ messages)

[PATCH] ARM: dts: alt: Add DA9063 PMIC node
 2019-03-08 17:46 UTC  (9+ messages)

[PATCH v8 0/2] spi: Add Renesas R-Car Gen3 RPC-IF SPI driver
 2019-03-08 17:32 UTC  (5+ messages)
` [PATCH v8 1/2] spi: Add Renesas R-Car Gen3 RPC-IF SPI controller driver

[PATCH] rcar-csi2: Allow configuring of video standard
 2019-03-08 16:11 UTC  (8+ messages)

[PATCH] arm64: dts: renesas: r8a77990: Remove invalid compatible value for CSI40
 2019-03-08 14:49 UTC  (4+ messages)

[PATCH v3 00/31] v4l: add support for multiplexed streams
 2019-03-08 14:14 UTC  (18+ messages)
` [PATCH v3 12/31] media: entity: Add an iterator helper for connected pads
` [PATCH v3 19/31] media: Documentation: Add GS_ROUTING documentation
` [PATCH v3 28/31] adv748x: afe: Implement has_route()
` [PATCH v3 31/31] media: rcar-csi2: "

[PATCH] ARM: dts: r8a7792: blanche: Add IIC3 and DA9063 PMIC node
 2019-03-08 13:38 UTC  (2+ messages)

[PATCH v2 08/15] ARM: shmobile: fix a leaked reference by adding missing of_node_put
 2019-03-08 12:07 UTC  (2+ messages)

[PATCH] arm64: dts: renesas: r8a774c0-cat874: Add RWDT support
 2019-03-08 12:05 UTC  (3+ messages)

[RFC v3 0/2] Request GPIO when enabling interrupt
 2019-03-08  8:24 UTC  (6+ messages)
` [RFC v3 1/2] pinctrl: core: Add pinctrl_mux_gpio_request_enable

[PATCH 00/61] tree-wide: simplify getting .drvdata
 2019-03-07 20:58 UTC  (9+ messages)
` [PATCH 10/61] gpio: "

[PATCH net] ravb: Decrease TxFIFO depth of Q3 and Q2 to one
 2019-03-07 17:39 UTC  (3+ messages)

[PATCH 0/9] Add USB3.0 and TI HD3SS3220 driver support
 2019-03-07 16:02 UTC  (7+ messages)
` [PATCH 3/9] usb: typec: driver for TI HD3SS3220 USB Type-C DRP port controller
` [PATCH 4/9] usb: gadget: udc: renesas_usb3: use extcon framework to receive connect/disconnect

[PATCH/RFC] driver core: Postpone DMA tear-down until after devres release
 2019-03-07 15:12 UTC  (9+ messages)

[PATCH V2] regulator: gpio: Reword the binding document
 2019-03-07  9:12 UTC  (10+ messages)


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox