Re: [PATCH v4] i2c: spacemit: configure ILCR for accurate SCL frequency

[Yixun Lan <dlan@gentoo.org>]

On 15:27 Fri 17 Oct     , Troy Mitchell wrote:
> The SpacemiT I2C controller's SCL (Serial Clock Line) frequency for
> master mode operations is determined by the ILCR (I2C Load Count Register).
> Previously, the driver relied on the hardware's reset default
> values for this register.
> 
> The hardware's default ILCR values (SLV=0x156, FLV=0x5d) yield SCL
> frequencies lower than intended. For example, with the default
> 31.5 MHz input clock, these default settings result in an SCL
> frequency of approximately 93 kHz (standard mode) when targeting 100 kHz,
> and approximately 338 kHz (fast mode) when targeting 400 kHz.
> These frequencies are below the 100 kHz/400 kHz nominal speeds.
> 
> This patch integrates the SCL frequency management into
> the Common Clock Framework (CCF). Specifically, the ILCR register,
> which acts as a frequency divider for the SCL clock, is now registered
> as a managed clock (scl_clk) within the CCF.
> 
> This patch also cleans up unnecessary whitespace
> in the included header files.
> 
> Signed-off-by: Troy Mitchell <troy.mitchell@linux.spacemit.com>
Reviewed-by: Yixun Lan <dlan@gentoo.org>

> ---
> Changelog in v4:
> - initialize clk_init_data with {} so that init.flags is implicitly set to 0
> - minor cleanup and style fixes for better readability
> - remove unused spacemit_i2c_scl_clk_exclusive_put() cleanup callback
> - replace clk_set_rate_exclusive()/clk_rate_exclusive_put() pair with clk_set_rate()
> - simplify LCR LV field macros by using FIELD_GET/FIELD_MAX helpers
> - Link to v3: https://lore.kernel.org/all/20250814-k1-i2c-ilcr-v3-1-317723e74bcd@linux.spacemit.com/
..
-- 
Yixun Lan (dlan)

_______________________________________________
linux-riscv mailing list
linux-riscv@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-riscv