[PATCH v2 4/6] riscv: dts: spacemit: enable QSPI and add SPI NOR on Milk-V Jupiter

[Aurelien Jarno <aurelien@aurel32.net>]

Add the QSPI controller node for the Milk-V Jupiter board and describe
the attached SPI NOR flash (GD25Q64E).

The flash supports a frequency up to 133MHz (80 MHz for reads), and the
SoC supports a frequency up to 104 MHz. However tests have shown that
the flash is not reliably detected above 26.5 MHz, consistent with
frequency used in the vendor kernel. Therefore, use this frequency.

The m25p,fast-read properties is taken from the vendor kernel, and the
GD25Q64E datasheet confirms tha the fast read opcodes are supported.

Add a corresponding flash partition layout, matching the layout and the
names used in the vendor U-Boot.

Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Reviewed-by: Javier Martinez Canillas <javierm@redhat.com>
---
 .../boot/dts/spacemit/k1-milkv-jupiter.dts    | 43 ++++++++++++++++++-
 1 file changed, 42 insertions(+), 1 deletion(-)

v2:
 - Remove bootph-pre-ram property from SPI NOR flash and update the patch description accordingly
 - Mention that the fast read opcodes is marked as supported in the datasheet
 - Collect Reviewed-by:

diff --git a/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts b/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
index 836311c3f035c..bac6438c67532 100644
--- a/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
+++ b/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
@@ -173,7 +173,7 @@ buck3_1v8: buck3 {
 				regulator-always-on;
 			};
 
-			buck4 {
+			buck4_3v3: buck4 {
 				regulator-min-microvolt = <500000>;
 				regulator-max-microvolt = <3300000>;
 				regulator-ramp-delay = <5000>;
@@ -256,6 +256,47 @@ dldo7 {
 	};
 };
 
+&qspi {
+	pinctrl-names = "default";
+	pinctrl-0 = <&qspi_cfg>;
+	status = "okay";
+
+	flash@0 {
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		spi-max-frequency = <26500000>;
+		spi-rx-bus-width = <4>;
+		spi-tx-bus-width = <4>;
+		vcc-supply = <&buck4_3v3>; /* QSPI_VCC1833 */
+		m25p,fast-read;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			bootinfo@0 {
+				reg = <0x0 0x10000>;
+			};
+			private@10000 {
+				reg = <0x10000 0x10000>;
+			};
+			fsbl@20000 {
+				reg = <0x20000 0x40000>;
+			};
+			env@60000 {
+				reg = <0x60000 0x10000>;
+			};
+			opensbi@70000 {
+				reg = <0x70000 0x30000>;
+			};
+			uboot@a00000 {
+				reg = <0xa0000 0x760000>;
+			};
+		};
+	};
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_2_cfg>;
-- 
2.51.0


_______________________________________________
linux-riscv mailing list
linux-riscv@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-riscv