From: Heiko Stuebner <heiko-4mtYJXux2i+zQB+pC5nmwQ@public.gmane.org>
To: Vicente Bergas <vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>,
Enric Balletbo i Serra
<enric.balletbo-ZGY8ohtN/8qB+jHODAdFcQ@public.gmane.org>
Cc: William wu <wulf-TNX95d0MmH7DzftRWevZcw@public.gmane.org>,
linux-rockchip-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org
Subject: Re: [PATCH] arm64: rockchip: dts: sapphire: Fix USB3 Type-C.
Date: Fri, 14 Jun 2019 11:47:21 +0200 [thread overview]
Message-ID: <12195113.EL5Iorepzr@phil> (raw)
In-Reply-To: <20190522150717.1748-1-vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
Hi Vicente,
Am Mittwoch, 22. Mai 2019, 17:07:17 CEST schrieb Vicente Bergas:
> Before this patch, the Type-C port on the Sapphire board is dead.
>
> Applying only the power supply part of this patch, makes the port work
> for about 4 seconds at start-up. This is a sample trace with a memory
> stick plugged in:
> 1.- The memory stick LED lights on and kernel reports:
> [ 4.782999] scsi 0:0:0:0: Direct-Access USB DISK PMAP PQ: 0 ANSI: 4
> [ 5.904580] sd 0:0:0:0: [sdb] 3913344 512-byte logical blocks: (2.00 GB/1.87 GiB)
> [ 5.906860] sd 0:0:0:0: [sdb] Write Protect is off
> [ 5.908973] sd 0:0:0:0: [sdb] Mode Sense: 23 00 00 00
> [ 5.909122] sd 0:0:0:0: [sdb] No Caching mode page found
> [ 5.911214] sd 0:0:0:0: [sdb] Assuming drive cache: write through
> [ 5.951585] sdb: sdb1
> [ 5.954816] sd 0:0:0:0: [sdb] Attached SCSI removable disk
> 2.- 4 seconds later the memory stick LED lights off and kernel reports:
> [ 9.082822] phy phy-ff770000.syscon:usb2-phy@e450.2: charger = USB_DCP_CHARGER
> 3.- After a minute the kernel reports:
> [ 71.666761] usb 5-1: USB disconnect, device number 2
> It has been checked that, although the LED is off, VBUS is present.
>
> Applying the full patch makes it work.
> It has only been tested in host mode.
>
> Signed-off-by: Vicente Bergas <vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
having to set the regulator to always-on indicates more an issue
with the phy? Because in theory the phy-driver should just enable the
supplying regulator on power-on.
Like would it work to just add the regulator to the host-port of the
phy without enabling it all the time?
Thanks
Heiko
> ---
> arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi b/arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi
> index 04623e52ac5d..72000a7b666f 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk3399-sapphire.dtsi
> @@ -112,6 +112,7 @@
> pinctrl-names = "default";
> pinctrl-0 = <&vcc5v0_typec0_en>;
> regulator-name = "vcc5v0_typec0";
> + regulator-always-on;
> vin-supply = <&vcc_sys>;
> };
>
> @@ -565,12 +566,11 @@
> status = "okay";
>
> u2phy0_otg: otg-port {
> - phy-supply = <&vcc5v0_typec0>;
> status = "okay";
> };
>
> u2phy0_host: host-port {
> - phy-supply = <&vcc5v0_host>;
> + phy-supply = <&vcc5v0_typec0>;
> status = "okay";
> };
> };
> @@ -620,7 +620,7 @@
>
> &usbdrd_dwc3_0 {
> status = "okay";
> - dr_mode = "otg";
> + dr_mode = "host";
> };
>
> &usbdrd3_1 {
>
prev parent reply other threads:[~2019-06-14 9:47 UTC|newest]
Thread overview: 25+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-02-21 21:58 USB3 regression in RK3399 Vicente Bergas
[not found] ` <CAAMcf8B5zpgbTsCu9t0rs9+jWkwRdO2C+KbF+NOt3ZTQx36aZA-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2018-02-21 22:17 ` Heiko Stuebner
2018-02-21 23:04 ` Vicente Bergas
[not found] ` <CAAMcf8B5ffH-5Q3+PcjWwu5UeDk4ESZR0BNczaED+vnPLwge0w-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2018-02-22 9:10 ` Enric Balletbo i Serra
[not found] ` <c8e1bd5a-19ff-9d1c-7e78-b7e605fd1e6b-ZGY8ohtN/8qB+jHODAdFcQ@public.gmane.org>
2018-02-22 20:30 ` Vicente Bergas
[not found] ` <CAAMcf8C7Px_mC=dex3TqejBNYYUyJxrZHa1c7CbKXj6g==Cbyg-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2018-02-25 10:03 ` Vicente Bergas
[not found] ` <CAAMcf8DX4Mjuubnvwz9paMJ9oDYaNX-EKwFpsP9a-RfhHgO5Hg-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2018-02-26 12:26 ` Enric Balletbo i Serra
2018-02-26 16:34 ` Enric Balletbo i Serra
[not found] ` <9e64e878-07c8-912c-c597-7da7b3f96dd6-ZGY8ohtN/8qB+jHODAdFcQ@public.gmane.org>
2018-02-26 18:38 ` Vicente Bergas
2018-09-08 19:00 ` [PATCH 0/4] arm64: dts: Sapphire board: miscelaneous fixes Vicente Bergas
[not found] ` <20180908190048.14231-1-vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2018-09-08 19:00 ` [PATCH 1/4] arm64: dts: Sapphire board: re-order vcc_sys Vicente Bergas
[not found] ` <20180908190048.14231-2-vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2018-09-10 12:15 ` Heiko Stuebner
2018-09-08 19:00 ` [PATCH 2/4] arm64: dts: Sapphire board: Fix VCC5V0_HOST_EN Vicente Bergas
[not found] ` <20180908190048.14231-3-vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2018-09-10 12:16 ` Heiko Stuebner
2018-09-08 19:00 ` [PATCH 3/4] arm64: dts: Sapphire board has DVS2 disabled Vicente Bergas
[not found] ` <20180908190048.14231-4-vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2018-09-10 12:17 ` Heiko Stuebner
2018-09-08 19:00 ` [PATCH 4/4] arm64: dts: Sapphire board: Fix Type-C port supply Vicente Bergas
[not found] ` <20180908190048.14231-5-vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2018-09-10 12:23 ` Heiko Stuebner
2018-09-10 13:39 ` Vicente Bergas
[not found] ` <CAAMcf8Dr6Kfgx6aqy0vk9TBjW1=0sDp=zJAetjAt5AhPVwHDdA-JsoAwUIsXosN+BqQ9rBEUg@public.gmane.org>
2018-09-10 14:10 ` Heiko Stuebner
2018-09-10 16:10 ` [PATCH v2] arm64: dts: rockchip: Fix Type-C port supply in Sapphire board Vicente Bergas
[not found] ` <20180910161029.1948-1-vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2018-09-10 17:19 ` Heiko Stuebner
2019-05-18 12:29 ` Vicente Bergas
[not found] ` <574f2bae-0121-4cc7-ad9a-5ba32315d71b-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2019-05-22 15:07 ` [PATCH] arm64: rockchip: dts: sapphire: Fix USB3 Type-C Vicente Bergas
[not found] ` <20190522150717.1748-1-vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>
2019-06-14 9:47 ` Heiko Stuebner [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=12195113.EL5Iorepzr@phil \
--to=heiko-4mtyjxux2i+zqb+pc5nmwq@public.gmane.org \
--cc=enric.balletbo-ZGY8ohtN/8qB+jHODAdFcQ@public.gmane.org \
--cc=linux-rockchip-IAPFreCvJWM7uuMidbF8XUB+6BGkLq7r@public.gmane.org \
--cc=vicencb-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org \
--cc=wulf-TNX95d0MmH7DzftRWevZcw@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox