Re: [PATCH v7 3/5] usb: dwc3: make usb2 phy utmi interface configurable in DT

[Rob Herring <robh-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>]

On Thu, Jul 14, 2016 at 04:59:20PM +0800, William Wu wrote:
> Add snps,phyif-utmi-width devicetree property to configure
> the UTMI+ PHY with an 8- or 16-bit interface. UTMI+ PHY
> interface is a hardware property, and it's platform dependent.
> Normally,the PHYIF can be configured during coreconsultant.
           ^
space

> But for some specific USB cores(e.g. rk3399 SoC DWC3), the
> default PHYIF configuration value is fault, so we need to
> reconfigure it by software.
> 
> And refer to the DWC3 databook, the GUSB2PHYCFG.USBTRDTIM
> must be set to the corresponding value according to the
> UTMI+ PHY interface.
> 
> Signed-off-by: William Wu <william.wu-TNX95d0MmH7DzftRWevZcw@public.gmane.org>
> ---
> Changes in v7:
> - remove quirk and use only one property to configure utmi (Heiko, Rob Herring)
> 
> Changes in v6:
> - use '-' instead of '_' in dts (Rob Herring)
> 
> Changes in v5:
> - None
> 
> Changes in v4:
> - rebase on top of balbi testing/next, remove pdata (balbi)
> 
> Changes in v3:
> - None
> 
> Changes in v2:
> - add a quirk for phyif_utmi (balbi)
> 
>  Documentation/devicetree/bindings/usb/dwc3.txt |  3 +++
>  drivers/usb/dwc3/core.c                        | 25 +++++++++++++++++++++++++
>  drivers/usb/dwc3/core.h                        | 10 ++++++++++
>  3 files changed, 38 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/usb/dwc3.txt b/Documentation/devicetree/bindings/usb/dwc3.txt
> index 020b0e9..00cc541 100644
> --- a/Documentation/devicetree/bindings/usb/dwc3.txt
> +++ b/Documentation/devicetree/bindings/usb/dwc3.txt
> @@ -47,6 +47,9 @@ Optional properties:
>   - snps,hird-threshold: HIRD threshold
>   - snps,hsphy_interface: High-Speed PHY interface selection between "utmi" for
>     UTMI+ and "ulpi" for ULPI when the DWC_USB3_HSPHY_INTERFACE has value 3.
> + - snps,phyif-utmi-width: the value to configure the core to support a UTMI+ PHY
> +			with an 8- or 16-bit interface. Value 8 select 8-bit
> +			interface, value 16 select 16-bit interface.

Is 'phy_type = "utmi_wide"' not the same as 16-bit width?

Again, I think this should be common.

Rob
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html