From: John Keeping <john@metanate.com>
To: Mark Yao <mark.yao@rock-chips.com>
Cc: Heiko Stuebner <heiko@sntech.de>,
linux-kernel@vger.kernel.org, dri-devel@lists.freedesktop.org,
linux-rockchip@lists.infradead.org,
John Keeping <john@metanate.com>,
linux-arm-kernel@lists.infradead.org
Subject: [PATCH 21/26] drm/rockchip: dw-mipi-dsi: use positive check for N{H, V}SYNC
Date: Mon, 19 Sep 2016 18:17:39 +0100 [thread overview]
Message-ID: <20160919171747.28512-30-john@metanate.com> (raw)
In-Reply-To: <20160919171747.28512-1-john@metanate.com>
This matches other drivers.
Signed-off-by: John Keeping <john@metanate.com>
---
drivers/gpu/drm/rockchip/dw-mipi-dsi.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
index ae7c330cb7ac..2b26a54972da 100644
--- a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
+++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
@@ -772,9 +772,9 @@ static void dw_mipi_dsi_dpi_config(struct dw_mipi_dsi *dsi)
break;
}
- if (!(mode->flags & DRM_MODE_FLAG_PVSYNC))
+ if (mode->flags & DRM_MODE_FLAG_NVSYNC)
val |= VSYNC_ACTIVE_LOW;
- if (!(mode->flags & DRM_MODE_FLAG_PHSYNC))
+ if (mode->flags & DRM_MODE_FLAG_NHSYNC)
val |= HSYNC_ACTIVE_LOW;
dsi_write(dsi, DSI_DPI_VCID, DPI_VID(dsi->channel));
--
2.10.0.278.g4f427b1.dirty
next prev parent reply other threads:[~2016-09-19 17:17 UTC|newest]
Thread overview: 42+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-09-19 17:17 [PATCH 00/27] drm/rockchip: MIPI fixes & improvements John Keeping
2016-09-19 17:17 ` [PATCH 01/26] drm/rockchip: dw-mipi-dsi: use mode from display state John Keeping
2017-01-17 10:38 ` [01/26] " Chris Zhong
2017-01-18 2:21 ` Mark yao
2016-09-19 17:17 ` [PATCH 03/26] drm/rockchip: dw-mipi-dsi: don't configure hardware in mode_set for MIPI John Keeping
2016-09-19 17:17 ` [PATCH 04/26] drm/rockchip: dw-mipi-dsi: rename commit hook to enable John Keeping
2016-09-19 17:17 ` [PATCH 05/26] drm/rockchip: dw-mipi-dsi: fix command header writes John Keeping
2017-01-17 9:32 ` [05/26] " Chris Zhong
2016-09-19 17:17 ` [PATCH 07/26] drm/rockchip: dw-mipi-dsi: avoid out-of-bounds read on tx_buf John Keeping
2016-09-19 17:17 ` [PATCH 08/26] drm/rockchip: dw-mipi-dsi: include bad value in error message John Keeping
2016-09-19 17:17 ` [PATCH 09/26] drm/rockchip: dw-mipi-dsi: respect message flags John Keeping
2016-09-19 17:17 ` [PATCH 10/26] drm/rockchip: dw-mipi-dsi: only request HS clock when required John Keeping
2016-09-19 17:17 ` [PATCH 11/26] drm/rockchip: dw-mipi-dsi: don't assume buffer is aligned John Keeping
2016-09-19 17:17 ` [PATCH 12/26] drm/rockchip: dw-mipi-dsi: prepare panel after phy init John Keeping
2016-09-19 17:17 ` [PATCH 14/26] drm/rockchip: dw-mipi-dsi: fix escape clock rate John Keeping
2016-09-19 17:17 ` [PATCH 14/27] drm/rockchip: dw-mipi-dsi: use specific poll helper John Keeping
2016-09-19 17:17 ` [PATCH 15/26] drm/rockchip: dw-mipi-dsi: ensure PHY is reset John Keeping
[not found] ` <20160919171747.28512-1-john-HooS5bfzL4hWk0Htik3J/w@public.gmane.org>
2016-09-19 17:17 ` [PATCH 02/26] drm/rockchip: dw-mipi-dsi: pass new mode into MIPI mode set John Keeping
2016-09-19 17:17 ` [PATCH 06/26] drm/rockchip: dw-mipi-dsi: fix generic packet status check John Keeping
2016-09-19 17:17 ` [PATCH 13/26] drm/rockchip: dw-mipi-dsi: allow commands in panel_disable John Keeping
2016-09-19 17:17 ` [PATCH 15/27] drm/rockchip: dw-mipi-dsi: use positive check for N{H, V}SYNC John Keeping
2016-09-19 17:17 ` [PATCH 16/27] drm/rockchip: dw-mipi-dsi: fix escape clock rate John Keeping
2016-09-19 17:17 ` [PATCH 17/26] drm/rockchip: dw-mipi-dsi: don't enable PHY PLL until it's configured John Keeping
2016-09-19 17:17 ` [PATCH 18/26] drm/rockchip: dw-mipi-dsi: properly configure PHY timing John Keeping
2016-09-19 17:17 ` [PATCH 20/26] drm/rockchip: dw-mipi-dsi: use specific poll helper John Keeping
2016-09-19 17:17 ` [PATCH 21/27] drm/rockchip: dw-mipi-dsi: improve PLL configuration John Keeping
2016-09-19 17:17 ` [PATCH 16/26] drm/rockchip: dw-mipi-dsi: configure bias and bandgap before enable John Keeping
2016-09-19 17:17 ` [PATCH 17/27] drm/rockchip: dw-mipi-dsi: ensure PHY is reset John Keeping
2016-09-19 17:17 ` [PATCH 18/27] drm/rockchip: dw-mipi-dsi: configure bias and bandgap before enable John Keeping
2016-09-19 17:17 ` [PATCH 19/27] drm/rockchip: dw-mipi-dsi: don't enable PHY PLL until it's configured John Keeping
2016-09-19 17:17 ` [PATCH 19/26] drm/rockchip: dw-mipi-dsi: improve PLL configuration John Keeping
2016-09-19 17:17 ` [PATCH 20/27] drm/rockchip: dw-mipi-dsi: properly configure PHY timing John Keeping
2016-09-19 17:17 ` John Keeping [this message]
2016-09-19 17:17 ` [PATCH 22/27] drm/rockchip: dw-mipi-dsi: defer probe if panel is not loaded John Keeping
2016-09-19 17:17 ` [PATCH 22/26] drm/rockchip: vop: test for P{H,V}SYNC John Keeping
2016-09-19 17:17 ` [PATCH 23/26] drm/rockchip: dw-mipi-dsi: defer probe if panel is not loaded John Keeping
2016-09-19 17:17 ` [PATCH 23/27] drm/rockchip: dw-mipi-dsi: support non-burst modes John Keeping
2016-09-19 17:17 ` [PATCH 24/26] " John Keeping
2016-09-19 17:17 ` [PATCH 24/27] drm/rockchip: vop: test for P{H,V}SYNC John Keeping
2016-09-19 17:17 ` [PATCH 25/26] drm/rockchip: dw-mipi-dsi: add reset control John Keeping
2016-09-19 17:17 ` [PATCH 26/26] drm/rockchip: dw-mipi-dsi: support read commands John Keeping
2016-09-19 17:24 ` [PATCH 00/27] drm/rockchip: MIPI fixes & improvements John Keeping
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20160919171747.28512-30-john@metanate.com \
--to=john@metanate.com \
--cc=dri-devel@lists.freedesktop.org \
--cc=heiko@sntech.de \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=mark.yao@rock-chips.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox