Re: [PATCH 2/3] drm/rockchip: add ability to handle external dphys in mipi-dsi

[Laurent Pinchart <laurent.pinchart@ideasonboard.com>]

Hi Heiko,

Thank you for the patch.

On Wed, Nov 06, 2019 at 12:26:49PM +0100, Heiko Stuebner wrote:
> While the common case is that the dsi controller uses an internal dphy,
> accessed through the phy registers inside the dsi controller, there is
> also the possibility to use a separate dphy from a different vendor.
> 
> One such case is the Rockchip px30 that uses a Innosilicon Mipi dphy,
> so add the support for handling such a constellation, including the pll
> also getting generated inside that external phy.
> 
> Signed-off-by: Heiko Stuebner <heiko.stuebner@theobroma-systems.com>
> ---
>  .../display/rockchip/dw_mipi_dsi_rockchip.txt |  7 ++-
>  .../gpu/drm/rockchip/dw-mipi-dsi-rockchip.c   | 54 ++++++++++++++++++-
>  2 files changed, 57 insertions(+), 4 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/display/rockchip/dw_mipi_dsi_rockchip.txt b/Documentation/devicetree/bindings/display/rockchip/dw_mipi_dsi_rockchip.txt
> index ce4c1fc9116c..8b25156a9dcf 100644
> --- a/Documentation/devicetree/bindings/display/rockchip/dw_mipi_dsi_rockchip.txt
> +++ b/Documentation/devicetree/bindings/display/rockchip/dw_mipi_dsi_rockchip.txt
> @@ -8,8 +8,9 @@ Required properties:
>  	      "rockchip,rk3399-mipi-dsi", "snps,dw-mipi-dsi".
>  - reg: Represent the physical address range of the controller.
>  - interrupts: Represent the controller's interrupt to the CPU(s).
> -- clocks, clock-names: Phandles to the controller's pll reference
> -  clock(ref) and APB clock(pclk). For RK3399, a phy config clock
> +- clocks, clock-names: Phandles to the controller's and APB clock(pclk)
> +  and either a pll reference clock(ref) (internal dphy) or pll clock(pll)
> +  (when connected to an external phy). For RK3399, a phy config clock

Why does external PHY clock need to be specified here ? Shouldn't it be
handled by the PHY instead ?

>    (phy_cfg) and a grf clock(grf) are required. As described in [1].
>  - rockchip,grf: this soc should set GRF regs to mux vopl/vopb.
>  - ports: contain a port node with endpoint definitions as defined in [2].
> @@ -18,6 +19,8 @@ Required properties:
>  - video port 1 for either a panel or subsequent encoder
>  
>  Optional properties:
> +- phys: from general PHY binding: the phandle for the PHY device.
> +- phy-names: Should be "dphy" if phys references an external phy.
>  - power-domains: a phandle to mipi dsi power domain node.
>  - resets: list of phandle + reset specifier pairs, as described in [3].
>  - reset-names: string reset name, must be "apb".
> diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
> index bc073ec5c183..99ec625e0448 100644
> --- a/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
> +++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
> @@ -12,6 +12,7 @@
>  #include <linux/mfd/syscon.h>
>  #include <linux/module.h>
>  #include <linux/of_device.h>
> +#include <linux/phy/phy.h>
>  #include <linux/pm_runtime.h>
>  #include <linux/regmap.h>
>  
> @@ -223,6 +224,9 @@ struct dw_mipi_dsi_rockchip {
>  	bool is_slave;
>  	struct dw_mipi_dsi_rockchip *slave;
>  
> +	/* optional external dphy */
> +	struct phy *phy;
> +
>  	unsigned int lane_mbps; /* per lane */
>  	u16 input_div;
>  	u16 feedback_div;
> @@ -359,6 +363,9 @@ static int dw_mipi_dsi_phy_init(void *priv_data)
>  	struct dw_mipi_dsi_rockchip *dsi = priv_data;
>  	int ret, i, vco;
>  
> +	if (dsi->phy)
> +		return 0;
> +
>  	/*
>  	 * Get vco from frequency(lane_mbps)
>  	 * vco	frequency table
> @@ -467,6 +474,27 @@ static int dw_mipi_dsi_phy_init(void *priv_data)
>  	return ret;
>  }
>  
> +static void dw_mipi_dsi_phy_power_on(void *priv_data)
> +{
> +	struct dw_mipi_dsi_rockchip *dsi = priv_data;
> +	int ret;
> +
> +	ret = phy_set_mode(dsi->phy, PHY_MODE_MIPI_DPHY);
> +	if (ret) {
> +		DRM_DEV_ERROR(dsi->dev, "failed to set phy mode: %d\n", ret);
> +		return;
> +	}
> +
> +	phy_power_on(dsi->phy);
> +}
> +
> +static void dw_mipi_dsi_phy_power_off(void *priv_data)
> +{
> +	struct dw_mipi_dsi_rockchip *dsi = priv_data;
> +
> +	phy_power_off(dsi->phy);
> +}
> +
>  static int
>  dw_mipi_dsi_get_lane_mbps(void *priv_data, const struct drm_display_mode *mode,
>  			  unsigned long mode_flags, u32 lanes, u32 format,
> @@ -504,9 +532,21 @@ dw_mipi_dsi_get_lane_mbps(void *priv_data, const struct drm_display_mode *mode,
>  				      "DPHY clock frequency is out of range\n");
>  	}
>  
> -	fin = clk_get_rate(dsi->pllref_clk);
>  	fout = target_mbps * USEC_PER_SEC;
>  
> +	/* an external phy does have a controllable pll clk */
> +	if (dsi->phy) {
> +		fout = clk_round_rate(dsi->pllref_clk, fout);
> +		clk_set_rate(dsi->pllref_clk, fout);
> +
> +		dsi->lane_mbps = target_mbps;
> +		*lane_mbps = dsi->lane_mbps;
> +
> +		return 0;
> +	}
> +
> +	fin = clk_get_rate(dsi->pllref_clk);
> +
>  	/* constraint: 5Mhz <= Fref / N <= 40MHz */
>  	min_prediv = DIV_ROUND_UP(fin, 40 * USEC_PER_SEC);
>  	max_prediv = fin / (5 * USEC_PER_SEC);
> @@ -561,6 +601,8 @@ dw_mipi_dsi_get_lane_mbps(void *priv_data, const struct drm_display_mode *mode,
>  
>  static const struct dw_mipi_dsi_phy_ops dw_mipi_dsi_rockchip_phy_ops = {
>  	.init = dw_mipi_dsi_phy_init,
> +	.power_on = dw_mipi_dsi_phy_power_on,
> +	.power_off = dw_mipi_dsi_phy_power_off,
>  	.get_lane_mbps = dw_mipi_dsi_get_lane_mbps,
>  };
>  
> @@ -920,7 +962,15 @@ static int dw_mipi_dsi_rockchip_probe(struct platform_device *pdev)
>  		return -EINVAL;
>  	}
>  
> -	dsi->pllref_clk = devm_clk_get(dev, "ref");
> +	/* try to get a possible external dphy */
> +	dsi->phy = devm_phy_optional_get(dev, "dphy");
> +	if (IS_ERR(dsi->phy)) {
> +		ret = PTR_ERR(dsi->phy);
> +		DRM_DEV_ERROR(dev, "failed to get mipi dphy: %d\n", ret);
> +		return ret;
> +	}
> +
> +	dsi->pllref_clk = devm_clk_get(dev, dsi->phy ? "pll" : "ref");
>  	if (IS_ERR(dsi->pllref_clk)) {
>  		ret = PTR_ERR(dsi->pllref_clk);
>  		DRM_DEV_ERROR(dev,

-- 
Regards,

Laurent Pinchart