[PATCH] arm64: dts: rockchip: set num-cs property for spi on px30

[Heiko Stuebner <heiko@sntech.de>]

From: Heiko Stuebner <heiko.stuebner@cherry.de>

The px30 has two spi controllers with two chip-selects each.
The num-cs property is specified as the total number of chip
selects a controllers has and is used since 2020 to find uses
of chipselects outside that range in the Rockchip spi driver.

Without the property set, the default is 1, so spi devices
using the second chipselect will not be created.

Fixes: eb1262e3cc8b ("spi: spi-rockchip: use num-cs property and ctlr->enable_gpiods")
Signed-off-by: Heiko Stuebner <heiko.stuebner@cherry.de>
---
 arch/arm64/boot/dts/rockchip/px30.dtsi | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/rockchip/px30.dtsi b/arch/arm64/boot/dts/rockchip/px30.dtsi
index 42ce78beb413..20955556b624 100644
--- a/arch/arm64/boot/dts/rockchip/px30.dtsi
+++ b/arch/arm64/boot/dts/rockchip/px30.dtsi
@@ -632,6 +632,7 @@ spi0: spi@ff1d0000 {
 		clock-names = "spiclk", "apb_pclk";
 		dmas = <&dmac 12>, <&dmac 13>;
 		dma-names = "tx", "rx";
+		num-cs = <2>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&spi0_clk &spi0_csn &spi0_miso &spi0_mosi>;
 		#address-cells = <1>;
@@ -647,6 +648,7 @@ spi1: spi@ff1d8000 {
 		clock-names = "spiclk", "apb_pclk";
 		dmas = <&dmac 14>, <&dmac 15>;
 		dma-names = "tx", "rx";
+		num-cs = <2>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&spi1_clk &spi1_csn0 &spi1_csn1 &spi1_miso &spi1_mosi>;
 		#address-cells = <1>;
-- 
2.39.2


_______________________________________________
Linux-rockchip mailing list
Linux-rockchip@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-rockchip