[PATCH v1 4/5] rtc: pcf8523: external capacitor configuration

[Sam Ravnborg <sam@ravnborg.org>]

From: Søren Andersen <san@skov.dk>

Add support for specifying the quartz load in the DT node.
The pcf8523 may use either a 7 pF or an 12.5 pF xtal.
If the rtc has the wrong configuration the time will
drift several hours/week.

If nothing is specified in DT then the factory default of 7 pF is used.
This is a change compared to before where the driver assumed 12.5 pF.

Note: all kernel dts trees are updated with the new property.

Signed-off-by: Søren Andersen <san@skov.dk>
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Cc: Alessandro Zummo <a.zummo@towertech.it>
Cc: Alexandre Belloni <alexandre.belloni@bootlin.com>
---
 drivers/rtc/rtc-pcf8523.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/rtc/rtc-pcf8523.c b/drivers/rtc/rtc-pcf8523.c
index 453615f8ac9a..3c19b4d21a2d 100644
--- a/drivers/rtc/rtc-pcf8523.c
+++ b/drivers/rtc/rtc-pcf8523.c
@@ -85,7 +85,7 @@ static int pcf8523_write(struct i2c_client *client, u8 reg, u8 value)
 	return 0;
 }
 
-static int pcf8523_select_capacitance(struct i2c_client *client, bool high)
+static int pcf8523_select_capacitance(struct i2c_client *client)
 {
 	u8 value;
 	int err;
@@ -94,7 +94,7 @@ static int pcf8523_select_capacitance(struct i2c_client *client, bool high)
 	if (err < 0)
 		return err;
 
-	if (!high)
+	if (!device_property_present(&client->dev, "nxp,quartz_load_12.5pf"))
 		value &= ~REG_CONTROL1_CAP_SEL;
 	else
 		value |= REG_CONTROL1_CAP_SEL;
@@ -331,7 +331,7 @@ static int pcf8523_probe(struct i2c_client *client,
 	if (!pcf)
 		return -ENOMEM;
 
-	err = pcf8523_select_capacitance(client, true);
+	err = pcf8523_select_capacitance(client);
 	if (err < 0)
 		return err;
 
-- 
2.12.0