[RESEND] rtc: hym8563: try multiple times to init device

[Frank Wunderlich <linux@fw-web.de>]

From: Peter Geis <pgwipeout@gmail.com>

RTC sometimes does not respond the first time in init.
Try multiple times to get a response.

Signed-off-by: Peter Geis <pgwipeout@gmail.com>
Signed-off-by: Frank Wunderlich <frank-w@public-files.de>
---
discussion from v1
https://patchwork.kernel.org/project/linux-rockchip/patch/20220608161150.58919-2-linux@fw-web.de/

On Fri, Jul 8, 2022 at 12:18 PM Robin Murphy <robin.murphy@arm.com> wrote:
> FWIW, given that HYM8563 is fairly common on RK3288 boards - I can't say
> I've ever noticed an issue with mine, for instance - it seems dubious
> that this would be a general issue of the chip itself. Are you sure it's
> not a SoC or board-level issue with the I2C bus being in a funny initial
> state, timings being marginal, or suchlike?

Peter Geis <pgwipeout@gmail.com>:
I don't think this is an SoC issue since this is the first instance
I've encountered it. Mind you we don't have the reset lines hooked up
at all for the Rockchip i2c driver, so it's possible that's the case,
but I'd imagine it would be observed more broadly if that was the
case. I've tried pushing the timings out pretty far as well as bumping
up the drive strength to no change. It seems to occur only with the
hym rtc used on this board. I suspect it's a new variant of the hym
that has slightly different behavior.
---
 drivers/rtc/rtc-hym8563.c | 11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/rtc/rtc-hym8563.c b/drivers/rtc/rtc-hym8563.c
index cc710d682121..d9d0b6615a07 100644
--- a/drivers/rtc/rtc-hym8563.c
+++ b/drivers/rtc/rtc-hym8563.c
@@ -13,6 +13,7 @@
 #include <linux/clk-provider.h>
 #include <linux/i2c.h>
 #include <linux/bcd.h>
+#include <linux/delay.h>
 #include <linux/rtc.h>
 
 #define HYM8563_CTL1		0x00
@@ -438,10 +439,16 @@ static irqreturn_t hym8563_irq(int irq, void *dev_id)
 
 static int hym8563_init_device(struct i2c_client *client)
 {
-	int ret;
+	int ret, i;
 
 	/* Clear stop flag if present */
-	ret = i2c_smbus_write_byte_data(client, HYM8563_CTL1, 0);
+	for (i = 0; i < 3; i++) {
+		ret = i2c_smbus_write_byte_data(client, HYM8563_CTL1, 0);
+		if (ret == 0)
+			break;
+		msleep(20);
+	}
+
 	if (ret < 0)
 		return ret;
 
-- 
2.34.1