From mboxrd@z Thu Jan 1 00:00:00 1970 From: "didier" Subject: RE: Pb between an UltraTrak SX8000 and an Adaptec 29160 Date: Mon, 18 Nov 2002 08:01:13 -0500 Sender: linux-scsi-owner@vger.kernel.org Message-ID: <000501c28f02$934b3000$13e2cf82@darkwolf> References: <47810000.1037389984@localhost> Reply-To: Mime-Version: 1.0 Content-Type: text/plain; charset="US-ASCII" Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <47810000.1037389984@localhost> List-Id: linux-scsi@vger.kernel.org To: "'Justin T. Gibbs'" , linux-scsi@vger.kernel.org The UltraTrak was updated to the latest available firmware before connected to the server. I e-mailed promise tech-support last week but did not get any answer so far. On a different note, who should I contact regarding the display bug: Nov 14 11:04:35 dagdhasrv kernel: (scsi0:A:0): 160.000MB/s transfers (80.000MHz DT, offset 62, 16bit) Nov 14 11:04:35 dagdhasrv kernel: SCSI device sda: -1951217920 512-byte hdwr sectors (100488 MB) ^^^^^^^^^^^ Nov 14 11:04:35 dagdhasrv kernel: Partition check: Nov 14 11:04:35 dagdhasrv kernel: sda: sda1 Thanks again, Didier. > > I have just connected a brand new UltraTrak SX8000 > > (from Promise with 8 x 200GB IDE drives) to an > > adaptec 29160. The UltraTrak SX8000 is connected > > via a brand new LVD cable (1meter). > > > > While everything seems fine, I am getting a bunch of > > > > (scsi0:A:0:0): parity error detected in Data-out phase. > SEQADDR(0x56) > > SCSIRATE(0xc2) > > No terminal CRC packet recevied > > I've never seen false positives from this diagnostic. It > looks like your Promise device is not properly implementing > DT transfers. Is there a firmware update for the device?