[PATCH 6/7] Erroneous TPG ID check in SCSI ALUA Handler

[Hannes Reinecke <hare@suse.de>]

For Target Portal Group IDs occupying the full 2 bytes in the
RTPG response, the following group_id check in the alua_rtpg
routine always fails in scsi_dh_alua.c:

if (h->group_id == (ucp[2] << 8) + ucp[3]) {

This causes the ALUA handler to wrongly identify the AAS of
a specified device as well as incorrectly interpreting the
supported AAS of the target as seen by the following entries
in the /var/log/messages:

"alua: port group 3ea state A supports tousna"
"alua: port group 3e9 state A supports tousna"

This is because 'ucp' is wrongly declared in alua_rtpg as
a character pointer instead of an unsigned character pointer.

Signed-off-by: Martin George <marting@netapp.com>
Signed-off-by: Hannes Reinecke <hare@suse.de>
---
 drivers/scsi/device_handler/scsi_dh_alua.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/scsi/device_handler/scsi_dh_alua.c b/drivers/scsi/device_handler/scsi_dh_alua.c
index f44dbf6..34c6611 100644
--- a/drivers/scsi/device_handler/scsi_dh_alua.c
+++ b/drivers/scsi/device_handler/scsi_dh_alua.c
@@ -504,7 +504,7 @@ static int alua_rtpg(struct scsi_device *sdev, struct alua_dh_data *h)
 {
 	struct scsi_sense_hdr sense_hdr;
 	int len, k, off, valid_states = 0;
-	char *ucp;
+	unsigned char *ucp;
 	unsigned err;
 	unsigned long expiry, interval = 10;
 
-- 
1.6.0.2