From: Saurav Kashyap <saurav.kashyap@qlogic.com>
To: jbottomley@parallels.com
Cc: giridhar.malavali@qlogic.com, saurav.kashyap@qlogic.com,
andrew.vasquez@qlogic.com, linux-scsi@vger.kernel.org
Subject: [PATCH 00/29] Update driver to 8.06.00.08-k
Date: Tue, 27 Aug 2013 01:37:26 -0400 [thread overview]
Message-ID: <1377581875-8574-1-git-send-email-saurav.kashyap@qlogic.com> (raw)
Hi James,
Please apply the following patches to the scsi tree, misc branch at your
earliest convenience.
Thanks,
~Saurav
Andrew Vasquez (1):
qla2xxx: Correct multiqueue offset calculations.
Andy Shevchenko (1):
qla2xxx: print MAC via %pMR.
Armen Baloyan (12):
qla2xxx: Set factory reset recovery timeout to 10 min. for ISPFX00.
qla2xxx: Perform warm reset every 2 minutes if firmware load fails
for ISPFX00.
qla2xxx: Add ISPFX00 specific bus reset routine.
qla2xxx: Notify ISPFX00 firmware when driver is unloaded or system is
shut down.
qla2xxx: Add critical temperature handling for ISPFX00.
qla2xxx: Add changes to support extended IOs for ISPFX00
qla2xxx: Add changes in initialization for ISPFX00 cards with BIOS
qla2xxx: Send all AENs for ISPFx00 to above layers.
qla2xxx: Remove handling of Shutdown Requested AEN from
qlafx00_process_aen().
qla2xxx: Correct Interrupt Register offset for ISPFX00
qla2xxx: QLAFX00 make over temperature AEN handling informational,
add log for normal temperature AEN
qla2xxx: Set default critical temperature value in cases when ISPFX00
firmware doesn't provide it
Atul Deshmukh (1):
qla2xxx: Add support for ISP8044.
Chad Dupuis (3):
qla2xxx: Remove QL_DEBUG_LEVEL_17 defines from qla_nx.c.
qla2xxx: Make log message that prints when a completion status
requires a port down more readable.
qla2xxx: Move queue depth ramp down message to i/o debug level.
Joe Carnuccio (6):
qla2xxx: Fix incorrect test after list_for_each_entry() exits.
qla2xxx: Add setting of driver version string for vendor application.
qla2xxx: Reconfigure thermal temperature.
qla2xxx: Add missing FCP statistics to sysfs interface.
qla2xxx: Select link initialization option bits from current
operating mode.
qla2xxx: Correctly print out/in mailbox registers.
Oleksandr Khoshaba (1):
qla2xxx: Print some variables to hexadecimal string via %*phN format
Santosh Vernekar (1):
qla2xxx: Add loopback IDC-TIME-EXTEND aen handling support.
Saurav Kashyap (2):
qla2xxx: Correction to message ids.
qla2xxx: Update the driver version to 8.06.00.08-k.
Sawan Chandak (1):
qla2xxx: Add a new interface to update versions.
drivers/scsi/qla2xxx/Makefile | 2 +-
drivers/scsi/qla2xxx/qla_attr.c | 79 +-
drivers/scsi/qla2xxx/qla_bsg.c | 43 +-
drivers/scsi/qla2xxx/qla_dbg.c | 58 +-
drivers/scsi/qla2xxx/qla_def.h | 39 +-
drivers/scsi/qla2xxx/qla_fw.h | 2 +
drivers/scsi/qla2xxx/qla_gbl.h | 40 +
drivers/scsi/qla2xxx/qla_gs.c | 97 +-
drivers/scsi/qla2xxx/qla_init.c | 86 +-
drivers/scsi/qla2xxx/qla_inline.h | 2 +-
drivers/scsi/qla2xxx/qla_iocb.c | 17 +-
drivers/scsi/qla2xxx/qla_isr.c | 91 +-
drivers/scsi/qla2xxx/qla_mbx.c | 297 +++-
drivers/scsi/qla2xxx/qla_mid.c | 2 +
drivers/scsi/qla2xxx/qla_mr.c | 164 ++-
drivers/scsi/qla2xxx/qla_mr.h | 35 +-
drivers/scsi/qla2xxx/qla_nx.c | 117 +-
drivers/scsi/qla2xxx/qla_nx.h | 10 +
drivers/scsi/qla2xxx/qla_nx2.c | 3716 ++++++++++++++++++++++++++++++++++++
drivers/scsi/qla2xxx/qla_nx2.h | 551 ++++++
drivers/scsi/qla2xxx/qla_os.c | 213 ++-
drivers/scsi/qla2xxx/qla_sup.c | 162 ++-
drivers/scsi/qla2xxx/qla_target.c | 69 +-
drivers/scsi/qla2xxx/qla_version.h | 4 +-
drivers/scsi/qla2xxx/tcm_qla2xxx.c | 14 +-
25 files changed, 5427 insertions(+), 483 deletions(-)
create mode 100644 drivers/scsi/qla2xxx/qla_nx2.c
create mode 100644 drivers/scsi/qla2xxx/qla_nx2.h
--
1.7.7
next reply other threads:[~2013-08-27 6:06 UTC|newest]
Thread overview: 34+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-08-27 5:37 Saurav Kashyap [this message]
2013-08-27 5:37 ` [PATCH 01/29] qla2xxx: Print some variables to hexadecimal string via %*phN format Saurav Kashyap
2013-08-27 5:37 ` [PATCH 02/29] qla2xxx: Add support for ISP8044 Saurav Kashyap
2013-08-28 7:15 ` James Bottomley
2013-08-28 13:33 ` Saurav Kashyap
2013-08-27 5:37 ` [PATCH 03/29] qla2xxx: Fix incorrect test after list_for_each_entry() exits Saurav Kashyap
2013-08-27 5:37 ` [PATCH 04/29] qla2xxx: Correct multiqueue offset calculations Saurav Kashyap
2013-08-27 5:37 ` [PATCH 05/29] qla2xxx: Set factory reset recovery timeout to 10 min. for ISPFX00 Saurav Kashyap
2013-08-27 5:37 ` [PATCH 06/29] qla2xxx: Perform warm reset every 2 minutes if firmware load fails " Saurav Kashyap
2013-08-27 5:37 ` [PATCH 07/29] qla2xxx: Add ISPFX00 specific bus reset routine Saurav Kashyap
2013-08-27 5:37 ` [PATCH 08/29] qla2xxx: Remove QL_DEBUG_LEVEL_17 defines from qla_nx.c Saurav Kashyap
2013-08-27 5:37 ` [PATCH 09/29] qla2xxx: Add setting of driver version string for vendor application Saurav Kashyap
2013-08-27 5:37 ` [PATCH 10/29] qla2xxx: Reconfigure thermal temperature Saurav Kashyap
2013-08-27 5:37 ` [PATCH 11/29] qla2xxx: Notify ISPFX00 firmware when driver is unloaded or system is shut down Saurav Kashyap
2013-08-27 5:37 ` [PATCH 12/29] qla2xxx: Add critical temperature handling for ISPFX00 Saurav Kashyap
2013-08-27 5:37 ` [PATCH 13/29] qla2xxx: Make log message that prints when a completion status requires a port down more readable Saurav Kashyap
2013-08-27 5:37 ` [PATCH 14/29] qla2xxx: Add missing FCP statistics to sysfs interface Saurav Kashyap
2013-08-27 5:37 ` [PATCH 15/29] qla2xxx: Add changes to support extended IOs for ISPFX00 Saurav Kashyap
2013-08-27 5:37 ` [PATCH 16/29] qla2xxx: Add changes in initialization for ISPFX00 cards with BIOS Saurav Kashyap
2013-08-27 5:37 ` [PATCH 17/29] qla2xxx: Send all AENs for ISPFx00 to above layers Saurav Kashyap
2013-08-27 5:37 ` [PATCH 18/29] qla2xxx: Remove handling of Shutdown Requested AEN from qlafx00_process_aen() Saurav Kashyap
2013-08-27 5:37 ` [PATCH 19/29] qla2xxx: Correct Interrupt Register offset for ISPFX00 Saurav Kashyap
2013-08-27 5:37 ` [PATCH 20/29] qla2xxx: QLAFX00 make over temperature AEN handling informational, add log for normal temperature AEN Saurav Kashyap
2013-08-27 5:37 ` [PATCH 21/29] qla2xxx: Set default critical temperature value in cases when ISPFX00 firmware doesn't provide it Saurav Kashyap
2013-08-27 5:37 ` [PATCH 22/29] qla2xxx: Add loopback IDC-TIME-EXTEND aen handling support Saurav Kashyap
2013-08-27 5:37 ` [PATCH 23/29] qla2xxx: Select link initialization option bits from current operating mode Saurav Kashyap
2013-08-27 5:37 ` [PATCH 24/29] qla2xxx: Move queue depth ramp down message to i/o debug level Saurav Kashyap
2013-08-27 5:37 ` [PATCH 25/29] qla2xxx: Add a new interface to update versions Saurav Kashyap
2013-08-27 5:37 ` [PATCH 26/29] qla2xxx: Correctly print out/in mailbox registers Saurav Kashyap
2013-08-27 5:37 ` [PATCH 27/29] qla2xxx: Correction to message ids Saurav Kashyap
2013-08-27 5:37 ` [PATCH 28/29] qla2xxx: print MAC via %pMR Saurav Kashyap
2013-08-27 5:37 ` [PATCH 29/29] qla2xxx: Update the driver version to 8.06.00.08-k Saurav Kashyap
2013-08-28 3:24 ` [PATCH 00/29] Update driver " James Bottomley
2013-08-28 4:31 ` Saurav Kashyap
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1377581875-8574-1-git-send-email-saurav.kashyap@qlogic.com \
--to=saurav.kashyap@qlogic.com \
--cc=andrew.vasquez@qlogic.com \
--cc=giridhar.malavali@qlogic.com \
--cc=jbottomley@parallels.com \
--cc=linux-scsi@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).