From: "Rafael J. Wysocki" <rjw@sisk.pl>
To: Luciano Rocha <luciano@eurotux.com>
Cc: Linux-Kernel <linux-kernel@vger.kernel.org>,
linux-usb@vger.kernel.org, Alan Stern <stern@rowland.harvard.edu>,
SCSI development list <linux-scsi@vger.kernel.org>
Subject: Re: usb hdd problems with 2.6.27.2
Date: Sat, 25 Oct 2008 21:25:43 +0200 [thread overview]
Message-ID: <200810252125.44184.rjw@sisk.pl> (raw)
In-Reply-To: <20081022162246.GB5649@bit.office.eurotux.com>
[Adding CCs]
On Wednesday, 22 of October 2008, Luciano Rocha wrote:
>
> Hello,
>
> An external HDD, usb-encased, works fine under 2.6.26.5, but under
> 2.6.27.2 I get hundreds of errors per second, of 'No Sense [current]'.
>
> On connection, under 2.6.26.5, I get the following:
>
> [ 84.503949] usb 1-2.1.1: new high speed USB device using ehci_hcd and address 8
> [ 84.696861] usb 1-2.1.1: configuration #1 chosen from 1 choice
> [ 84.740856] usbcore: registered new interface driver libusual
> [ 84.817625] Initializing USB Mass Storage driver...
> [ 84.817625] scsi2 : SCSI emulation for USB Mass Storage devices
> [ 84.818820] usbcore: registered new interface driver usb-storage
> [ 84.818823] USB Mass Storage support registered.
> [ 89.819567] scsi 2:0:0:0: Direct-Access SAMSUNG HD400LD WQ10 PQ: 0 ANSI: 0
> [ 89.857627] Driver 'sd' needs updating - please use bus_type methods
> [ 89.857837] sd 2:0:0:0: [sda] 781422769 512-byte hardware sectors (400088 MB)
> [ 89.858754] sd 2:0:0:0: [sda] Write Protect is off
> [ 89.858754] sd 2:0:0:0: [sda] Assuming drive cache: write through
> [ 89.858869] sd 2:0:0:0: [sda] 781422769 512-byte hardware sectors (400088 MB)
> [ 89.858869] sd 2:0:0:0: [sda] Write Protect is off
> [ 89.858869] sd 2:0:0:0: [sda] Assuming drive cache: write through
> [ 89.858869] sda: sda1
> [ 89.879851] sd 2:0:0:0: [sda] Attached SCSI disk
> [ 89.901630] sd 2:0:0:0: Attached scsi generic sg0 type 0
> [ 89.963632] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 89.963632] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 106.913629] kjournald starting. Commit interval 5 seconds
> [ 106.913629] EXT3 FS on dm-5, internal journal
>
> On 2.6.27.2, I get:
>
> [ 551.484341] usb 1-2.1.1: new high speed USB device using ehci_hcd and address 8
> [ 551.677467] usb 1-2.1.1: configuration #1 chosen from 1 choice
> [ 551.718201] usbcore: registered new interface driver libusual
> [ 551.799287] Initializing USB Mass Storage driver...
> [ 551.800330] scsi2 : SCSI emulation for USB Mass Storage devices
> [ 551.800694] usbcore: registered new interface driver usb-storage
> [ 551.800698] USB Mass Storage support registered.
> [ 556.800702] scsi 2:0:0:0: Direct-Access SAMSUNG HD400LD WQ10 PQ: 0 ANSI: 0
> [ 556.835190] Driver 'sd' needs updating - please use bus_type methods
> [ 556.835928] sd 2:0:0:0: [sda] 781422769 512-byte hardware sectors (400088 MB)
> [ 556.836809] sd 2:0:0:0: [sda] Write Protect is off
> [ 556.836816] sd 2:0:0:0: [sda] Assuming drive cache: write through
> [ 556.837548] sd 2:0:0:0: [sda] 781422769 512-byte hardware sectors (400088 MB)
> [ 556.838296] sd 2:0:0:0: [sda] Write Protect is off
> [ 556.838307] sd 2:0:0:0: [sda] Assuming drive cache: write through
> [ 556.838310] sda: sda1
> [ 556.859169] sd 2:0:0:0: [sda] Attached SCSI disk
> [ 556.878553] sd 2:0:0:0: Attached scsi generic sg0 type 0
> [ 556.946044] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.946055] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.947290] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.947298] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.948539] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.948547] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.949790] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.949798] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.951045] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.951053] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.952290] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.952297] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.954665] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.954673] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.957665] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.957673] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.960791] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.960799] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.963790] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
> [ 556.963798] sd 2:0:0:0: [sda] Add. Sense: No additional sense information
> [ 556.966915] sd 2:0:0:0: [sda] Sense Key : No Sense [current]
>
> These repeat forever, till I disconnect.
>
> Regards,
> Luciano Rocha
>
next parent reply other threads:[~2008-10-25 19:21 UTC|newest]
Thread overview: 24+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <20081022162246.GB5649@bit.office.eurotux.com>
2008-10-25 19:25 ` Rafael J. Wysocki [this message]
[not found] ` <200810252125.44184.rjw-KKrjLPT3xs0@public.gmane.org>
2008-10-25 19:50 ` usb hdd problems with 2.6.27.2 Alan Stern
2008-10-25 20:11 ` James Bottomley
2008-10-26 14:05 ` Luciano Rocha
2008-10-27 11:14 ` Luciano Rocha
2008-10-27 11:28 ` Luciano Rocha
[not found] ` <20081027112803.GA4398-oEplIgxCSygGFt9iVWuREaMaJEuR8uiQ@public.gmane.org>
2008-10-27 14:24 ` Alan Stern
2008-10-27 14:56 ` Douglas Gilbert
[not found] ` <4905D68D.7030407-qazKcTl6WRFWk0Htik3J/w@public.gmane.org>
2008-10-27 15:08 ` Boaz Harrosh
[not found] ` <4905D986.6050001-C4P08NqkoRlBDgjK7y7TUQ@public.gmane.org>
2008-10-27 16:26 ` Kay Sievers
2008-10-27 15:25 ` Alan Stern
2008-10-27 15:33 ` James Bottomley
2008-10-27 15:18 ` Luciano Rocha
2008-10-27 15:38 ` Alan Stern
[not found] ` <Pine.LNX.4.44L0.0810271134530.15462-100000-IYeN2dnnYyZXsRXLowluHWD2FQJk+8+b@public.gmane.org>
2008-10-27 16:53 ` Luciano Rocha
[not found] ` <20081027165306.GA3875-oEplIgxCSygGFt9iVWuREaMaJEuR8uiQ@public.gmane.org>
2008-10-27 20:10 ` Alan Stern
2008-10-28 16:37 ` Luciano Rocha
[not found] ` <20081028163722.GA4374-oEplIgxCSygGFt9iVWuREaMaJEuR8uiQ@public.gmane.org>
2008-10-28 17:38 ` Alan Stern
2008-11-03 15:52 ` Luciano Rocha
[not found] ` <20081103155254.GA3368-oEplIgxCSygGFt9iVWuREaMaJEuR8uiQ@public.gmane.org>
2008-11-03 19:46 ` Alan Stern
2008-11-05 10:26 ` Luciano Rocha
2008-11-05 16:51 ` Alan Stern
2008-11-13 17:10 ` Luciano Rocha
2008-10-27 20:36 ` Alan Stern
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=200810252125.44184.rjw@sisk.pl \
--to=rjw@sisk.pl \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-scsi@vger.kernel.org \
--cc=linux-usb@vger.kernel.org \
--cc=luciano@eurotux.com \
--cc=stern@rowland.harvard.edu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox