From: "Stephen M. Cameron" <scameron@beardog.cce.hp.com>
To: linux-scsi@vger.kernel.org
Cc: James.Bottomley@HansenPartnership.com, dab@hp.com,
mikem@beardog.cce.hp.com
Subject: [PATCH 00/24] hpsa updates for May 2010
Date: Thu, 27 May 2010 15:12:36 -0500 [thread overview]
Message-ID: <20100527200301.3116.78973.stgit@beardog.cce.hp.com> (raw)
hpsa: The following series implements mostly small cleanups in the
initialization code with the aim to make hpsa_pci_init() a little
smaller and more readable. Fixed a bug that some ioremapped
memory was not being unmapped in all cases. Fixed a minor
bug that would cause large commands (many scatter gather elements)
to not be fetched out of host memory in a single transaction. Added
some documentation and an entry in MAINTAINERS. Added /sys entry
to show controller firmware revision.
---
Stephen M. Cameron (24):
hpsa: save pdev pointer in per hba structure early to avoid passing it around so much.
hpsa: factor out hpsa_lookup_board_id
hpsa: factor out hpsa_board_disabled
hpsa: remove redundant board_id parameter from hpsa_interrupt_mode
hpsa: factor out hpsa_find_memory_BAR
hpsa: factor out hpsa_wait_for_board_ready
hpsa: factor out hpsa_find_cfgtables
hpsa: fix leak of ioremapped memory
hpsa: hpsa factor out hpsa_find_board_params
hpsa: factor out hpsa-CISS-signature-present
hpsa: factor out hpsa_enable_scsi_prefetch
hpsa: factor out hpsa_p600_dma_prefetch_quirk
hpsa: factor out hpsa_enter_simple_mode
hpsa: check that simple mode is supported
hpsa: clean up debug ifdefs
hpsa: mark hpsa_mark_hpsa_put_ctlr_into_performant_mode as __devinit
hpsa: factor out hpsa_wait_for_mode_change_ack
hpsa: remove unused variable trans_offset
hpsa: factor out hpsa_enter_performant_mode
hpsa: remove unused firm_ver member of the per-hba structure
hpsa: Add hpsa.txt to Documentation/scsi
hpsa: expose controller firmware revision via /sys.
hpsa: fix block fetch table problem.
hpsa: add entry to MAINTAINERS
Documentation/scsi/hpsa.txt | 107 ++++++++++
MAINTAINERS | 8 +
drivers/scsi/hpsa.c | 440 ++++++++++++++++++++++++++-----------------
drivers/scsi/hpsa.h | 1
4 files changed, 381 insertions(+), 175 deletions(-)
create mode 100644 Documentation/scsi/hpsa.txt
--
Signature
next reply other threads:[~2010-05-27 20:08 UTC|newest]
Thread overview: 27+ messages / expand[flat|nested] mbox.gz Atom feed top
2010-05-27 20:12 Stephen M. Cameron [this message]
2010-05-27 20:12 ` [PATCH 01/24] hpsa: save pdev pointer in per hba structure early to avoid passing it around so much Stephen M. Cameron
2010-05-27 20:12 ` [PATCH 02/24] hpsa: factor out hpsa_lookup_board_id Stephen M. Cameron
2010-05-27 20:12 ` [PATCH 03/24] hpsa: factor out hpsa_board_disabled Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 04/24] hpsa: remove redundant board_id parameter from hpsa_interrupt_mode Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 05/24] hpsa: factor out hpsa_find_memory_BAR Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 06/24] hpsa: factor out hpsa_wait_for_board_ready Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 07/24] hpsa: factor out hpsa_find_cfgtables Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 08/24] hpsa: fix leak of ioremapped memory Stephen M. Cameron
2010-05-28 19:12 ` Rolf Eike Beer
2010-06-01 12:55 ` scameron
2010-05-27 20:13 ` [PATCH 09/24] hpsa: hpsa factor out hpsa_find_board_params Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 10/24] hpsa: factor out hpsa-CISS-signature-present Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 11/24] hpsa: factor out hpsa_enable_scsi_prefetch Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 12/24] hpsa: factor out hpsa_p600_dma_prefetch_quirk Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 13/24] hpsa: factor out hpsa_enter_simple_mode Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 14/24] hpsa: check that simple mode is supported Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 15/24] hpsa: clean up debug ifdefs Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 16/24] hpsa: mark hpsa_mark_hpsa_put_ctlr_into_performant_mode as __devinit Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 17/24] hpsa: factor out hpsa_wait_for_mode_change_ack Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 18/24] hpsa: remove unused variable trans_offset Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 19/24] hpsa: factor out hpsa_enter_performant_mode Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 20/24] hpsa: remove unused firm_ver member of the per-hba structure Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 21/24] hpsa: Add hpsa.txt to Documentation/scsi Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 22/24] hpsa: expose controller firmware revision via /sys Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 23/24] hpsa: fix block fetch table problem Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 24/24] hpsa: add entry to MAINTAINERS Stephen M. Cameron
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20100527200301.3116.78973.stgit@beardog.cce.hp.com \
--to=scameron@beardog.cce.hp.com \
--cc=James.Bottomley@HansenPartnership.com \
--cc=dab@hp.com \
--cc=linux-scsi@vger.kernel.org \
--cc=mikem@beardog.cce.hp.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).