linux-scsi.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: "Stephen M. Cameron" <scameron@beardog.cce.hp.com>
To: linux-scsi@vger.kernel.org
Cc: James.Bottomley@HansenPartnership.com, dab@hp.com,
	mikem@beardog.cce.hp.com
Subject: [PATCH 13/24] hpsa: factor out hpsa_enter_simple_mode
Date: Thu, 27 May 2010 15:13:48 -0500	[thread overview]
Message-ID: <20100527201348.3116.28176.stgit@beardog.cce.hp.com> (raw)
In-Reply-To: <20100527200301.3116.78973.stgit@beardog.cce.hp.com>

From: Stephen M. Cameron <scameron@beardog.cce.hp.com>

hpsa: factor out hpsa_enter_simple_mode

Signed-off-by: Stephen M. Cameron <scameron@beardog.cce.hp.com>
---
 drivers/scsi/hpsa.c |   62 +++++++++++++++++++++++++++++----------------------
 1 files changed, 35 insertions(+), 27 deletions(-)

diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c
index 86da45b..bb1b86e 100644
--- a/drivers/scsi/hpsa.c
+++ b/drivers/scsi/hpsa.c
@@ -3418,9 +3418,41 @@ static inline void hpsa_p600_dma_prefetch_quirk(struct ctlr_info *h)
 	writel(dma_prefetch, h->vaddr + I2O_DMA1_CFG);
 }
 
+static int __devinit hpsa_enter_simple_mode(struct ctlr_info *h)
+{
+	int i;
+
+	h->max_commands = readl(&(h->cfgtable->CmdsOutMax));
+	/* Update the field, and then ring the doorbell */
+	writel(CFGTBL_Trans_Simple, &(h->cfgtable->HostWrite.TransportRequest));
+	writel(CFGTBL_ChangeReq, h->vaddr + SA5_DOORBELL);
+
+	/* under certain very rare conditions, this can take awhile.
+	 * (e.g.: hot replace a failed 144GB drive in a RAID 5 set right
+	 * as we enter this code.)
+	 */
+	for (i = 0; i < MAX_CONFIG_WAIT; i++) {
+		if (!(readl(h->vaddr + SA5_DOORBELL) & CFGTBL_ChangeReq))
+			break;
+		/* delay and try again */
+		msleep(10);
+	}
+
+#ifdef HPSA_DEBUG
+	print_cfg_table(&h->pdev->dev, h->cfgtable);
+#endif				/* HPSA_DEBUG */
+
+	if (!(readl(&(h->cfgtable->TransportActive)) & CFGTBL_Trans_Simple)) {
+		dev_warn(&h->pdev->dev,
+			"unable to get board into simple mode\n");
+		return -ENODEV;
+	}
+	return 0;
+}
+
 static int __devinit hpsa_pci_init(struct ctlr_info *h)
 {
-	int i, prod_index, err;
+	int prod_index, err;
 
 	prod_index = hpsa_lookup_board_id(h->pdev, &h->board_id);
 	if (prod_index < 0)
@@ -3467,33 +3499,9 @@ static int __devinit hpsa_pci_init(struct ctlr_info *h)
 	}
 	hpsa_enable_scsi_prefetch(h);
 	hpsa_p600_dma_prefetch_quirk(h);
-
-	h->max_commands = readl(&(h->cfgtable->CmdsOutMax));
-	/* Update the field, and then ring the doorbell */
-	writel(CFGTBL_Trans_Simple, &(h->cfgtable->HostWrite.TransportRequest));
-	writel(CFGTBL_ChangeReq, h->vaddr + SA5_DOORBELL);
-
-	/* under certain very rare conditions, this can take awhile.
-	 * (e.g.: hot replace a failed 144GB drive in a RAID 5 set right
-	 * as we enter this code.)
-	 */
-	for (i = 0; i < MAX_CONFIG_WAIT; i++) {
-		if (!(readl(h->vaddr + SA5_DOORBELL) & CFGTBL_ChangeReq))
-			break;
-		/* delay and try again */
-		msleep(10);
-	}
-
-#ifdef HPSA_DEBUG
-	print_cfg_table(&h->pdev->dev, h->cfgtable);
-#endif				/* HPSA_DEBUG */
-
-	if (!(readl(&(h->cfgtable->TransportActive)) & CFGTBL_Trans_Simple)) {
-		dev_warn(&h->pdev->dev,
-			"unable to get board into simple mode\n");
-		err = -ENODEV;
+	err = hpsa_enter_simple_mode(h);
+	if (err)
 		goto err_out_free_res;
-	}
 	return 0;
 
 err_out_free_res:


  parent reply	other threads:[~2010-05-27 20:09 UTC|newest]

Thread overview: 27+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2010-05-27 20:12 [PATCH 00/24] hpsa updates for May 2010 Stephen M. Cameron
2010-05-27 20:12 ` [PATCH 01/24] hpsa: save pdev pointer in per hba structure early to avoid passing it around so much Stephen M. Cameron
2010-05-27 20:12 ` [PATCH 02/24] hpsa: factor out hpsa_lookup_board_id Stephen M. Cameron
2010-05-27 20:12 ` [PATCH 03/24] hpsa: factor out hpsa_board_disabled Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 04/24] hpsa: remove redundant board_id parameter from hpsa_interrupt_mode Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 05/24] hpsa: factor out hpsa_find_memory_BAR Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 06/24] hpsa: factor out hpsa_wait_for_board_ready Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 07/24] hpsa: factor out hpsa_find_cfgtables Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 08/24] hpsa: fix leak of ioremapped memory Stephen M. Cameron
2010-05-28 19:12   ` Rolf Eike Beer
2010-06-01 12:55     ` scameron
2010-05-27 20:13 ` [PATCH 09/24] hpsa: hpsa factor out hpsa_find_board_params Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 10/24] hpsa: factor out hpsa-CISS-signature-present Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 11/24] hpsa: factor out hpsa_enable_scsi_prefetch Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 12/24] hpsa: factor out hpsa_p600_dma_prefetch_quirk Stephen M. Cameron
2010-05-27 20:13 ` Stephen M. Cameron [this message]
2010-05-27 20:13 ` [PATCH 14/24] hpsa: check that simple mode is supported Stephen M. Cameron
2010-05-27 20:13 ` [PATCH 15/24] hpsa: clean up debug ifdefs Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 16/24] hpsa: mark hpsa_mark_hpsa_put_ctlr_into_performant_mode as __devinit Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 17/24] hpsa: factor out hpsa_wait_for_mode_change_ack Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 18/24] hpsa: remove unused variable trans_offset Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 19/24] hpsa: factor out hpsa_enter_performant_mode Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 20/24] hpsa: remove unused firm_ver member of the per-hba structure Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 21/24] hpsa: Add hpsa.txt to Documentation/scsi Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 22/24] hpsa: expose controller firmware revision via /sys Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 23/24] hpsa: fix block fetch table problem Stephen M. Cameron
2010-05-27 20:14 ` [PATCH 24/24] hpsa: add entry to MAINTAINERS Stephen M. Cameron

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20100527201348.3116.28176.stgit@beardog.cce.hp.com \
    --to=scameron@beardog.cce.hp.com \
    --cc=James.Bottomley@HansenPartnership.com \
    --cc=dab@hp.com \
    --cc=linux-scsi@vger.kernel.org \
    --cc=mikem@beardog.cce.hp.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).