[libsas PATCH v10 9/9] libsas: sas_rediscover_dev did not look at the SMP exec status.

[Dan Williams <dan.j.williams@intel.com>]

From: Jeff Skirvin <jeffrey.d.skirvin@intel.com>

The discovery function "sas_rediscover_dev" had two bugs: 1) it did
not pay attention to the return status from the SMP task execution;
2) the stack variable used for the returned SAS address was compared
against 0 without being initialized.

Signed-off-by: Jeff Skirvin <jeffrey.d.skirvin@intel.com>
[djbw: todo sanitize smp_execute_task return values (see: residue)]
Signed-off-by: Dan Williams <dan.j.williams@intel.com>
---
 drivers/scsi/libsas/sas_expander.c |    7 ++++++-
 1 files changed, 6 insertions(+), 1 deletions(-)

diff --git a/drivers/scsi/libsas/sas_expander.c b/drivers/scsi/libsas/sas_expander.c
index cacf3fe..e9423f3 100644
--- a/drivers/scsi/libsas/sas_expander.c
+++ b/drivers/scsi/libsas/sas_expander.c
@@ -1980,6 +1980,7 @@ static int sas_rediscover_dev(struct domain_device *dev, int phy_id, bool last)
 	u8 sas_addr[8];
 	int res;
 
+	memset(sas_addr, 0, 8);
 	res = sas_get_phy_attached_dev(dev, phy_id, sas_addr, &type);
 	switch (res) {
 	case SMP_RESP_NO_PHY:
@@ -1992,9 +1993,13 @@ static int sas_rediscover_dev(struct domain_device *dev, int phy_id, bool last)
 		return res;
 	case SMP_RESP_FUNC_ACC:
 		break;
+	case -ECOMM:
+		break;
+	default:
+		return res;
 	}
 
-	if (SAS_ADDR(sas_addr) == 0) {
+	if ((SAS_ADDR(sas_addr) == 0) || (res == -ECOMM)) {
 		phy->phy_state = PHY_EMPTY;
 		sas_unregister_devs_sas_addr(dev, phy_id, last);
 		return res;