[PATCH 00/17] hpsa: resend updates for April, 2012

["Stephen M. Cameron" <scameron@beardog.cce.hp.com>]

The two big changes here are adding an abort handler, and using multiple
reply queues for command completions.  Updated the patch set since last
time to address comments:

	* Use pci_set_master(h->pdev) to enable bus mastering instead of 
	  doing it manually.

	* Retry driver initiated commands on SAM_STAT_TASK_SET_FULL
	  as well as SAM_STAT_BUSY and retry more than just 3 times,
	  backing off the retry rate.

	* Dropped the changes that used the new IS_ENABLED macro.

Matt Bondurant (1):
      hpsa: retry driver initiated commands on busy status

Matt Gates (2):
      hpsa: use multiple reply queues
      hpsa: refine interrupt handler locking for greater concurrency

Mike Miller (1):
      hpsa: add new RAID level "1(ADM)"

Stephen M. Cameron (13):
      hpsa: call pci_disable_device on driver unload
      hpsa: do not skip disabled devices
      hpsa: enable bus master bit after pci_enable_device
      hpsa: suppress excessively chatty error messages
      hpsa: do not read from controller unnecessarily in completion code
      hpsa: do not give up retry of driver cmds after only 3 retries
      hpsa: remove unused parameter from finish_cmd
      hpsa: add abort error handler function
      hpsa: do aborts two ways
      hpsa: factor out tail calls to next_command() in process_(non)indexed_cmd()
      hpsa: factor out hpsa_free_irqs_and_disable_msix
      hpsa: removed unused member maxQsinceinit
      hpsa: dial down lockup detection during firmware flash


 drivers/block/cciss.c   |    2 
 drivers/scsi/hpsa.c     |  682 ++++++++++++++++++++++++++++++++++++++---------
 drivers/scsi/hpsa.h     |   85 ++++--
 drivers/scsi/hpsa_cmd.h |   37 ++-
 4 files changed, 642 insertions(+), 164 deletions(-)

-- 
-- steve