Re: [PATCH 03/14] lpfc: in sli3 use configured sg_seg_cnt for sg_tablesize

[Sebastian Herbszt <herbszt@gmx.de>]

James Smart wrote:
> 
> From: Bodo Stroesser <bstroesser@ts.fujitsu.com>
> 
> Hi James,
> 
> We had some performance problems with RAID systems connected to LPe12k.
> AFAICS, the reason is a small bug in lpfc.ko, causing the IO-size to
> be smaller than expected.
> 
> The patch below fixes it for us.
> 
> Please CC me, I'm not on the list.
> 
> Best regards
> Bodo
> 
> ------------------------------------------------------
> 
> Currently the module parameter lpfc_sg_seg_count does not have effect
> for sli3 devices.
> 
> In lpfc_sli_driver_resource_setup(), which is used for sli3, the code
> writes the configured sg_seg_cnt into lpfc_template.sg_tablesize.
> But lpfc_template is the template used for sli4 only. Thus the value should
> correctly be written to lpfc_template_s3->sg_tablesize.
> 
> This patch is for kernel 4.1-rc5, but is tested with lpfc 10.2.405.26 only.
> 
> Signed-off-by: Bodo Stroesser <bstroesser@ts.fujitsu.com>
> Signed-off-by: James Smart <james.smart@avagotech.com>
> ---
>  drivers/scsi/lpfc/lpfc_init.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/scsi/lpfc/lpfc_init.c b/drivers/scsi/lpfc/lpfc_init.c
> index da9b6fc..81bfb2d 100644
> --- a/drivers/scsi/lpfc/lpfc_init.c
> +++ b/drivers/scsi/lpfc/lpfc_init.c
> @@ -4994,7 +4994,7 @@ lpfc_sli_driver_resource_setup(struct lpfc_hba *phba)
>  
>  	/* Initialize the host templates the configured values. */
>  	lpfc_vport_template.sg_tablesize = phba->cfg_sg_seg_cnt;
> -	lpfc_template.sg_tablesize = phba->cfg_sg_seg_cnt;
> +	lpfc_template_s3.sg_tablesize = phba->cfg_sg_seg_cnt;
>  
>  	/* There are going to be 2 reserved BDEs: 1 FCP cmnd + 1 FCP rsp */
>  	if (phba->cfg_enable_bg) {

Reviewed-by: Sebastian Herbszt <herbszt@gmx.de>