From: James Smart <jsmart2021@gmail.com>
To: linux-scsi@vger.kernel.org
Cc: James Smart <jsmart2021@gmail.com>,
Dick Kennedy <dick.kennedy@broadcom.com>,
James Smart <james.smart@broadcom.com>
Subject: [PATCH 12/17] lpfc: correct port registrations with nvme_fc
Date: Fri, 3 Nov 2017 15:56:23 -0700 [thread overview]
Message-ID: <20171103225628.24716-13-jsmart2021@gmail.com> (raw)
In-Reply-To: <20171103225628.24716-1-jsmart2021@gmail.com>
The driver currently registers any remote port that has NVME support.
It should only be registering target ports.
Register only target ports.
Signed-off-by: Dick Kennedy <dick.kennedy@broadcom.com>
Signed-off-by: James Smart <james.smart@broadcom.com>
---
drivers/scsi/lpfc/lpfc_hbadisc.c | 20 ++++++++++++--------
drivers/scsi/lpfc/lpfc_nvme.c | 3 ++-
2 files changed, 14 insertions(+), 9 deletions(-)
diff --git a/drivers/scsi/lpfc/lpfc_hbadisc.c b/drivers/scsi/lpfc/lpfc_hbadisc.c
index 4577330313c0..ffceebf420f4 100644
--- a/drivers/scsi/lpfc/lpfc_hbadisc.c
+++ b/drivers/scsi/lpfc/lpfc_hbadisc.c
@@ -4176,12 +4176,14 @@ lpfc_nlp_state_cleanup(struct lpfc_vport *vport, struct lpfc_nodelist *ndlp,
if (ndlp->nlp_fc4_type & NLP_FC4_NVME) {
vport->phba->nport_event_cnt++;
- if (vport->phba->nvmet_support == 0)
- /* Start devloss */
- lpfc_nvme_unregister_port(vport, ndlp);
- else
+ if (vport->phba->nvmet_support == 0) {
+ /* Start devloss if target. */
+ if (ndlp->nlp_type & NLP_NVME_TARGET)
+ lpfc_nvme_unregister_port(vport, ndlp);
+ } else {
/* NVMET has no upcall. */
lpfc_nlp_put(ndlp);
+ }
}
}
@@ -4205,11 +4207,13 @@ lpfc_nlp_state_cleanup(struct lpfc_vport *vport, struct lpfc_nodelist *ndlp,
ndlp->nlp_fc4_type & NLP_FC4_NVME) {
if (vport->phba->nvmet_support == 0) {
/* Register this rport with the transport.
- * Initiators take the NDLP ref count in
- * the register.
+ * Only NVME Target Rports are registered with
+ * the transport.
*/
- vport->phba->nport_event_cnt++;
- lpfc_nvme_register_port(vport, ndlp);
+ if (ndlp->nlp_type & NLP_NVME_TARGET) {
+ vport->phba->nport_event_cnt++;
+ lpfc_nvme_register_port(vport, ndlp);
+ }
} else {
/* Just take an NDLP ref count since the
* target does not register rports.
diff --git a/drivers/scsi/lpfc/lpfc_nvme.c b/drivers/scsi/lpfc/lpfc_nvme.c
index db1ed426f7e6..d3ada630b427 100644
--- a/drivers/scsi/lpfc/lpfc_nvme.c
+++ b/drivers/scsi/lpfc/lpfc_nvme.c
@@ -2473,7 +2473,8 @@ lpfc_nvme_unregister_port(struct lpfc_vport *vport, struct lpfc_nodelist *ndlp)
/* Sanity check ndlp type. Only call for NVME ports. Don't
* clear any rport state until the transport calls back.
*/
- if (ndlp->nlp_type & (NLP_NVME_TARGET | NLP_NVME_INITIATOR)) {
+
+ if (ndlp->nlp_type & NLP_NVME_TARGET) {
init_completion(&rport->rport_unreg_done);
/* No concern about the role change on the nvme remoteport.
--
2.13.1
next prev parent reply other threads:[~2017-11-03 22:56 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-11-03 22:56 [PATCH 00/17] lpfc updates for 11.4.0.5 James Smart
2017-11-03 22:56 ` [PATCH 01/17] lpfc: FLOGI failures are reported when connected to a private loop James Smart
2017-11-08 9:05 ` Hannes Reinecke
2017-11-08 18:57 ` James Smart
2017-11-03 22:56 ` [PATCH 02/17] lpfc: Expand WQE capability of every NVME hardware queue James Smart
2017-11-08 9:08 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 03/17] lpfc: Handle XRI_ABORTED_CQE in soft IRQ James Smart
2017-11-08 9:09 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 04/17] lpfc: Fix crash after bad bar setup on driver attachment James Smart
2017-11-08 9:24 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 05/17] lpfc: Fix NVME LS abort_xri James Smart
2017-11-08 9:24 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 06/17] lpfc: Raise maximum NVME sg list size for 256 elements James Smart
2017-11-08 9:24 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 07/17] lpfc: Driver fails to detect direct attach storage array James Smart
2017-11-08 9:25 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 08/17] lpfc: Fix display for debugfs queInfo James Smart
2017-11-08 9:26 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 09/17] lpfc: Adjust default value of lpfc_nvmet_mrq James Smart
2017-11-08 9:38 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 10/17] lpfc: Fix ndlp ref count for pt2pt mode issue RSCN James Smart
2017-11-20 13:16 ` Hannes Reinecke
2017-11-03 22:56 ` [PATCH 11/17] lpfc: Linux LPFC driver does not process all RSCNs James Smart
2017-11-03 22:56 ` James Smart [this message]
2017-11-03 22:56 ` [PATCH 13/17] lpfc: Correct driver deregistrations with host nvme transport James Smart
2017-11-03 22:56 ` [PATCH 14/17] lpfc: Fix crash during driver unload with running nvme traffic James Smart
2017-11-03 22:56 ` [PATCH 15/17] lpfc: Fix driver handling of nvme resources during unload James Smart
2017-11-03 22:56 ` [PATCH 16/17] lpfc: small sg cnt cleanup James Smart
2017-11-03 22:56 ` [PATCH 17/17] lpfc: update driver version to 11.4.0.5 James Smart
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20171103225628.24716-13-jsmart2021@gmail.com \
--to=jsmart2021@gmail.com \
--cc=dick.kennedy@broadcom.com \
--cc=james.smart@broadcom.com \
--cc=linux-scsi@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).