[RFC PATCH 2/5] arm64: dts: sdm845: add Inline Crypto Engine registers and clock

Eric Biggers
2020-01-10T06:18:28Z

Add the vendor-specific registers and clock for Qualcomm ICE (Inline
Crypto Engine) to the device tree node for the UFS host controller on
sdm845, so that the ufs-qcom driver will be able to use inline crypto.

Use a separate register range rather than extending the main UFS range
because there's a gap between the two, and the ICE registers are
vendor-specific. (Actually, the hardware claims that the ICE range also
includes the array of standard crypto configuration registers; however,
on this SoC the Linux kernel isn't permitted to access them directly.)

Signed-off-by: Eric Biggers <ebiggers@google.com>
---
arch/arm64/boot/dts/qcom/sdm845.dtsi | 13 +++++++++----
1 file changed, 9 insertions(+), 4 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sdm845.dtsi b/arch/arm64/boot/dts/qcom/sdm845.dtsi
index ddb1f23c936fe..0fecc0791959e 100644
--- a/arch/arm64/boot/dts/qcom/sdm845.dtsi
+++ b/arch/arm64/boot/dts/qcom/sdm845.dtsi
@@ -1367,7 +1367,9 @@ cache-controller@1100000 {
ufs_mem_hc: ufshc@1d84000 {
compatible = "qcom,sdm845-ufshc", "qcom,ufshc",
"jedec,ufs-2.0";
- reg = <0 0x01d84000 0 0x2500>;
+ reg = <0 0x01d84000 0 0x2500>,
+ <0 0 0 0>,
+ <0 0x01d90000 0 0x8000>;
interrupts = <GIC_SPI 265 IRQ_TYPE_LEVEL_HIGH>;
phys = <&ufs_mem_phy_lanes>;
phy-names = "ufsphy";
@@ -1385,7 +1387,8 @@ ufs_mem_hc: ufshc@1d84000 {
"ref_clk",
"tx_lane0_sync_clk",
"rx_lane0_sync_clk",
- "rx_lane1_sync_clk";
+ "rx_lane1_sync_clk",
+ "ice_core_clk";
clocks =
<&gcc GCC_UFS_PHY_AXI_CLK>,
<&gcc GCC_AGGRE_UFS_PHY_AXI_CLK>,
@@ -1394,7 +1397,8 @@ ufs_mem_hc: ufshc@1d84000 {
<&rpmhcc RPMH_CXO_CLK>,
<&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>,
<&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>,
- <&gcc GCC_UFS_PHY_RX_SYMBOL_1_CLK>;
+ <&gcc GCC_UFS_PHY_RX_SYMBOL_1_CLK>,
+ <&gcc GCC_UFS_PHY_ICE_CORE_CLK>;
freq-table-hz =
<50000000 200000000>,
<0 0>,
@@ -1403,7 +1407,8 @@ ufs_mem_hc: ufshc@1d84000 {
<0 0>,
<0 0>,
<0 0>,
- <0 0>;
+ <0 0>,
+ <0 300000000>;

status = "disabled";
};
--
2.24.1