[PATCH] lpfc: Correct BDE DMA address assignment for GEN_REQ_WQE

[James Smart <jsmart2021@gmail.com>]

Garbage FCoE CT frames are transmitted on the wire because of bad DMA ptr
addresses filled in the GEN_REQ_WQE.

The __lpfc_sli_prep_gen_req_s4() routine is using the wrong buffer for
the payload address. Change the dma buffer assignment from the bmp buffer
to the bpl buffer.

Fixes: 61910d6a5243 ("scsi: lpfc: SLI path split: Refactor CT paths")
Co-developed-by: Justin Tee <justin.tee@broadcom.com>
Signed-off-by: Justin Tee <justin.tee@broadcom.com>
Signed-off-by: James Smart <jsmart2021@gmail.com>
---
 drivers/scsi/lpfc/lpfc_sli.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/scsi/lpfc/lpfc_sli.c b/drivers/scsi/lpfc/lpfc_sli.c
index 79d2ef5f0f05..6ed696c4602a 100644
--- a/drivers/scsi/lpfc/lpfc_sli.c
+++ b/drivers/scsi/lpfc/lpfc_sli.c
@@ -10728,10 +10728,10 @@ __lpfc_sli_prep_gen_req_s4(struct lpfc_iocbq *cmdiocbq, struct lpfc_dmabuf *bmp,
 
 	/* Words 0 - 2 */
 	bde = (struct ulp_bde64_le *)&cmdwqe->generic.bde;
-	bde->addr_low = cpu_to_le32(putPaddrLow(bmp->phys));
-	bde->addr_high = cpu_to_le32(putPaddrHigh(bmp->phys));
+	bde->addr_low = bpl->addr_low;
+	bde->addr_high = bpl->addr_high;
 	bde->type_size = cpu_to_le32(xmit_len);
-	bde->type_size |= cpu_to_le32(ULP_BDE64_TYPE_BLP_64);
+	bde->type_size |= cpu_to_le32(ULP_BDE64_TYPE_BDE_64);
 
 	/* Word 3 */
 	cmdwqe->gen_req.request_payload_len = xmit_len;
-- 
2.26.2