RE: out of range LBA using sg_raw

[Kashyap Desai <kashyap.desai@broadcom.com>]

> -----Original Message-----
> From: Bart Van Assche [mailto:Bart.VanAssche@sandisk.com]
> Sent: Wednesday, March 08, 2017 9:35 PM
> To: hch@infradead.org; kashyap.desai@broadcom.com
> Cc: linux-scsi@vger.kernel.org; linux-kernel@vger.kernel.org
> Subject: Re: out of range LBA using sg_raw
>
> On Wed, 2017-03-08 at 21:29 +0530, Kashyap Desai wrote:
> > Also one more fault I can generate using below sg_raw command -
> >
> > "sg_raw -r 32k /dev/sdx 28 00 01 4f ff ff 00 00 08 00"
> >
> > Provide more scsi data length compare to actual SG buffer. Do you
> > suggest such SG_IO interface vulnerability is good to be captured in
driver.
>
> That's not a vulnerability of the SG I/O interface. A SCSI device has to
set the
> residual count correctly if the SCSI data length does not match the size
of the
> data buffer.

Thanks Bart.  I will pass this information to Broadcom firmware dev. May
be a Tx/Rx (DMA) related code in MR (also for Fusion IT HBA)  cannot
handle due to some sanity checks are not passed.

>
> Bart.