From: Thomas Babut <thomas@babut.net>
To: linux-scsi@vger.kernel.org
Cc: Matthew Wilcox <matthew@wil.cx>
Subject: Re: Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Adapter
Date: Fri, 19 Nov 2004 10:32:40 +0100 [thread overview]
Message-ID: <419DBDB8.2010805@babut.net> (raw)
In-Reply-To: <1099928314.10944.81.camel@compaq-rhel4.xsintricity.com>
Hi all,
yesterday I tried some new Kernels...
2.4.28-bk1 with sym53c8xx: works with normal Performance
Bootlog:
Nov 19 01:31:39 srv kernel: SCSI subsystem driver Revision: 1.00
Nov 19 01:31:39 srv kernel: sym53c8xx: at PCI bus 0, device 8, function 0
Nov 19 01:31:39 srv kernel: sym53c8xx: setting PCI_COMMAND_PARITY...(fix-up)
Nov 19 01:31:39 srv kernel: sym53c8xx: 53c1010-33 detected with Symbios
NVRAM
Nov 19 01:31:39 srv kernel: sym53c8xx: at PCI bus 0, device 8, function 1
Nov 19 01:31:39 srv kernel: sym53c8xx: setting PCI_COMMAND_PARITY...(fix-up)
Nov 19 01:31:39 srv kernel: sym53c8xx: 53c1010-33 detected with Symbios
NVRAM
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: rev 0x1 on pci bus 0 device
8 function 0 irq 9
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: Symbios format NVRAM, ID 7,
Fast-80, Parity Checking
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: on-chip RAM at 0xf9000000
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: restart (scsi reset).
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: handling phase mismatch
from SCRIPTS.
Nov 19 01:31:39 srv kernel: sym53c1010-33-0: Downloading SCSI SCRIPTS.
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: rev 0x1 on pci bus 0 device
8 function 1 irq 11
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: Symbios format NVRAM, ID 7,
Fast-80, Parity Checking
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: on-chip RAM at 0xf8000000
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: restart (scsi reset).
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: handling phase mismatch
from SCRIPTS.
Nov 19 01:31:39 srv kernel: sym53c1010-33-1: Downloading SCSI SCRIPTS.
Nov 19 01:31:39 srv kernel: scsi0 : sym53c8xx-1.7.3c-20010512
Nov 19 01:31:39 srv kernel: scsi1 : sym53c8xx-1.7.3c-20010512
Nov 19 01:31:39 srv kernel: blk: queue f7e9a018, I/O limit 1048575Mb
(mask 0xffffffffff)
Nov 19 01:31:39 srv kernel: Vendor: QUANTUM Model: ATLAS10K2-TY367J
Rev: DDD6
Nov 19 01:31:39 srv kernel: Type: Direct-Access
ANSI SCSI revision: 03
Nov 19 01:31:39 srv kernel: blk: queue f7e67e18, I/O limit 1048575Mb
(mask 0xffffffffff)
Nov 19 01:31:39 srv kernel: sym53c1010-33-0-<2,0>: tagged command queue
depth set to 8
Nov 19 01:31:39 srv kernel: Attached scsi disk sda at scsi0, channel 0,
id 2, lun 0
Nov 19 01:31:39 srv kernel: sym53c1010-33-0-<2,*>: FAST-40 SCSI 40.0
MB/s (25.0 ns, offset 31)
Nov 19 01:31:39 srv kernel: SCSI device sda: 71721820 512-byte hdwr
sectors (36722 MB)
Nov 19 01:31:39 srv kernel: Partition check:
Nov 19 01:31:39 srv kernel: sda: sda1 sda2
2.4.28-bk1 with sym53c8xx2: works, but poor performance (max. 5 MByte/s)
Bootlog:
Nov 19 01:27:19 srv kernel: SCSI subsystem driver Revision: 1.00
Nov 19 01:27:19 srv kernel: sym.0.8.0: setting PCI_COMMAND_PARITY...
Nov 19 01:27:19 srv kernel: sym.0.8.1: setting PCI_COMMAND_PARITY...
Nov 19 01:27:19 srv kernel: sym0: <1010-33> rev 0x1 on pci bus 0 device
8 function 0 irq 9
Nov 19 01:27:19 srv kernel: sym0: using 64 bit DMA addressing
Nov 19 01:27:19 srv kernel: sym0: Symbios NVRAM, ID 7, Fast-80, LVD,
parity checking
Nov 19 01:27:19 srv kernel: sym0: open drain IRQ line driver, using
on-chip SRAM
Nov 19 01:27:19 srv kernel: sym0: using LOAD/STORE-based firmware.
Nov 19 01:27:19 srv kernel: sym0: handling phase mismatch from SCRIPTS.
Nov 19 01:27:19 srv kernel: sym0: SCSI BUS has been reset.
Nov 19 01:27:19 srv kernel: sym1: <1010-33> rev 0x1 on pci bus 0 device
8 function 1 irq 11
Nov 19 01:27:19 srv kernel: sym1: using 64 bit DMA addressing
Nov 19 01:27:19 srv kernel: sym1: Symbios NVRAM, ID 7, Fast-80, LVD,
parity checking
Nov 19 01:27:19 srv kernel: sym1: open drain IRQ line driver, using
on-chip SRAM
Nov 19 01:27:19 srv kernel: sym1: using LOAD/STORE-based firmware.
Nov 19 01:27:19 srv kernel: sym1: handling phase mismatch from SCRIPTS.
Nov 19 01:27:19 srv kernel: sym1: SCSI BUS has been reset.
Nov 19 01:27:19 srv kernel: scsi0 : sym-2.1.17a
Nov 19 01:27:19 srv kernel: scsi1 : sym-2.1.17a
Nov 19 01:27:19 srv kernel: blk: queue f7e9a018, I/O limit 1048575Mb
(mask 0xffffffffff)
Nov 19 01:27:19 srv kernel: Vendor: QUANTUM Model: ATLAS10K2-TY367J
Rev: DDD6
Nov 19 01:27:19 srv kernel: Type: Direct-Access
ANSI SCSI revision: 03
Nov 19 01:27:19 srv kernel: blk: queue f7e64e18, I/O limit 1048575Mb
(mask 0xffffffffff)
Nov 19 01:27:19 srv kernel: sym0:2:0: tagged command queuing enabled,
command queue depth 16.
Nov 19 01:27:19 srv kernel: Attached scsi disk sda at scsi0, channel 0,
id 2, lun 0
Nov 19 01:27:19 srv kernel: sym0:2:0:M_REJECT to send for : 1-3-1-9-1f.
Nov 19 01:27:19 srv kernel: SCSI device sda: 71721820 512-byte hdwr
sectors (36722 MB)
Nov 19 01:27:19 srv kernel: Partition check:
Nov 19 01:27:19 srv kernel: sda: sda1 sda2
2.6.10-rc2-bk3 with sym53c8xx2: System doesn't come up, same errors as
before
No bootlog because of the lack of physical access to the machine.
I still would like to run Kernel 2.6. :)
Regards,
Thomas Babut
next prev parent reply other threads:[~2004-11-19 9:32 UTC|newest]
Thread overview: 20+ messages / expand[flat|nested] mbox.gz Atom feed top
2004-11-05 16:25 Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Ada pter SUPPORT
2004-11-05 17:01 ` Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Adapter Tony Battersby
2004-11-05 18:07 ` Matthew Wilcox
2004-11-05 20:36 ` Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Ada pter Matthew Wilcox
2004-11-05 23:44 ` Thomas Babut
2004-11-06 4:20 ` Doug Ledford
2004-11-08 14:44 ` Kernel 2.6.x hangs with Symbios Logic 53c1010 Ultra3 SCSI Adapter Tony Battersby
2004-11-08 15:38 ` Doug Ledford
2004-11-19 9:32 ` Thomas Babut [this message]
2004-11-23 1:39 ` Thomas Babut
2004-11-23 1:40 ` Matthew Wilcox
2004-11-27 19:52 ` Ingo Korb
-- strict thread matches above, loose matches on Subject: below --
2005-02-09 19:25 Thomas Babut
2004-11-05 16:07 Thomas Babut
2004-11-05 17:29 ` Tony Battersby
2004-11-05 12:52 Thomas Babut
2004-11-05 13:43 ` Matthew Wilcox
2004-11-05 13:59 ` Thomas Babut
2004-11-05 14:19 ` Matthew Wilcox
2004-11-05 14:27 ` Thomas Babut
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=419DBDB8.2010805@babut.net \
--to=thomas@babut.net \
--cc=linux-scsi@vger.kernel.org \
--cc=matthew@wil.cx \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).