Re: changes to ieee1394/sbp2 outside of linux1394.org

[Stefan Richter <stefanr@s5r6.in-berlin.de>]

Rogério Brito wrote:
> I just modprobe'd sd_mod by hand and the device was recognized:
[...]
> ieee1394: sbp2: Logged into SBP-2 device
> ieee1394: Node 0-00:1023: Max speed [S400] - Max payload [2048]
>   Vendor: ST316002  Model: 1A                Rev: 3.06
>   Type:   Unknown                            ANSI SCSI revision: 06
> SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)
[...]
> I had to load sd_mod by hand, though. The hotplug scripts didn't load it
> this time.

The .../device/type is 14, right?

In the scsi.agent patch I posted earlier I added that device number and its
association with sd_mod. However I must admit I did not test this patch in
the form that I posted since my distro uses a little different scsi.agent.

I could check your scsi.agent if you upload or post it although the necessary
addition is trivial.

But make sure hotplug is really active and not accidently disabled.
(E.g. sbp2 should be autoloaded too when ieee1394 detected an SBP-2 device.)
-- 
Stefan Richter
-=====-=-=-= -=== =----
http://arcgraph.de/sr/
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html