* LSI SAS2008-based controller does not export disks behind raid
@ 2011-02-17 13:58 Artem Bokhan
0 siblings, 0 replies; only message in thread
From: Artem Bokhan @ 2011-02-17 13:58 UTC (permalink / raw)
To: linux-scsi
Hello.
I have LSI SAS2008-based controller (mpt2sas driver). Old firmware exports disks
behind raid so they could be read by smartmontools, new one does not. Is this
firmware-only issue or behaviour could be forced by driver?
Old behavior:
[...]
Feb 2 23:57:03 ubuntu kernel: [ 3.745023] mpt2sas0: LSISAS2008:
FWVersion(04.00.00.00), ChipRevision(0x02), BiosVersion(07.03.00.00)
Feb 2 23:57:03 ubuntu kernel: [ 3.745028] mpt2sas0:
Protocol=(Initiator,Target), Capabilities=(Raid,TLR,EEDP,Snapshot Buffer,Diag
Trace Buffer,Task Set Full,NCQ)
Feb 2 23:57:03 ubuntu kernel: [ 3.745095] mpt2sas0: sending port enable !!
Feb 2 23:57:03 ubuntu kernel: [ 5.473091] mpt2sas0: host_add:
handle(0x0001), sas_addr(0x50030480004c4df0), phys(8)
Feb 2 23:57:03 ubuntu kernel: [ 7.108617] scsi 7:0:0:0: CD-ROM
TEAC DV-W28S-V D.0A PQ: 0 ANSI: 0
Feb 2 23:57:03 ubuntu kernel: [ 7.119447] sr0: scsi3-mmc drive: 24x/24x
writer dvd-ram cd/rw xa/form2 cdda tray
Feb 2 23:57:03 ubuntu kernel: [ 7.119453] Uniform CD-ROM driver Revision: 3.20
Feb 2 23:57:03 ubuntu kernel: [ 7.119639] sr 7:0:0:0: Attached scsi generic
sg0 type 5
Feb 2 23:57:03 ubuntu kernel: [ 12.707672] mpt2sas0: port enable: SUCCESS
Feb 2 23:57:03 ubuntu kernel: [ 13.086899] scsi 0:1:0:0: Direct-Access
LSI Logical Volume 3000 PQ: 0 ANSI: 6
Feb 2 23:57:03 ubuntu kernel: [ 13.088373] scsi 0:1:0:0: RAID1:
handle(0x0143), wwid(0x0c73dae32c7319bf), pd_count(2), type(SATA)
Feb 2 23:57:03 ubuntu kernel: [ 13.088380] scsi 0:1:0:0: qdepth(128),
tagged(1), simple(1), ordered(0), scsi_level(7), cmd_que(1)
Feb 2 23:57:03 ubuntu kernel: [ 13.088543] sd 0:1:0:0: Attached scsi generic
sg1 type 0
Feb 2 23:57:03 ubuntu kernel: [ 13.088899] sd 0:1:0:0: [sda] 488280064
512-byte logical blocks: (249 GB/232 GiB)
Feb 2 23:57:03 ubuntu kernel: [ 13.089446] sd 0:1:0:0: [sda] Write Protect is
off
Feb 2 23:57:03 ubuntu kernel: [ 13.089685] sd 0:1:0:0: [sda] Write cache:
disabled, read cache: enabled, doesn't support DPO or FUA
Feb 2 23:57:03 ubuntu kernel: [ 13.090558] sda:
Feb 2 23:57:03 ubuntu kernel: [ 13.090770] scsi 0:0:0:0: Direct-Access
ATA WDC WD2502ABYS-0 3B03 PQ: 0 ANSI: 5
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Feb 2 23:57:03 ubuntu kernel: [ 13.091155] scsi 0:0:0:0: SATA:
handle(0x0009), sas_addr(0x4433221102000000), device_name(0x4ee15001ce3badae)
Feb 2 23:57:03 ubuntu kernel: [ 13.091158] scsi 0:0:0:0: SATA:
enclosure_logical_id(0x50030480004c4df0), slot(2)
Feb 2 23:57:03 ubuntu kernel: [ 13.091355] scsi 0:0:0:0: atapi(n), ncq(y),
asyn_notify(n), smart(y), fua(y), sw_preserve(y)
Feb 2 23:57:03 ubuntu kernel: [ 13.091359] scsi 0:0:0:0: qdepth(32),
tagged(1), simple(1), ordered(0), scsi_level(6), cmd_que(1)
Feb 2 23:57:03 ubuntu kernel: [ 13.091430] scsi 0:0:0:0: Attached scsi
generic sg2 type 0
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Feb 2 23:57:03 ubuntu kernel: [ 13.106287] sda1 sda2 <
Feb 2 23:57:03 ubuntu kernel: [ 13.108938] scsi 0:0:1:0: Direct-Access
ATA WDC WD2502ABYS-0 3B03 PQ: 0 ANSI: 5
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Feb 2 23:57:03 ubuntu kernel: [ 13.109311] sda5 >
Feb 2 23:57:03 ubuntu kernel: [ 13.109622] scsi 0:0:1:0: SATA:
handle(0x000a), sas_addr(0x4433221103000000), device_name(0x4ee15001d696030a)
Feb 2 23:57:03 ubuntu kernel: [ 13.109628] scsi 0:0:1:0: SATA:
enclosure_logical_id(0x50030480004c4df0), slot(3)
Feb 2 23:57:03 ubuntu kernel: [ 13.109743] scsi 0:0:1:0: atapi(n), ncq(y),
asyn_notify(n), smart(y), fua(y), sw_preserve(y)
Feb 2 23:57:03 ubuntu kernel: [ 13.109747] scsi 0:0:1:0: qdepth(32),
tagged(1), simple(1), ordered(0), scsi_level(6), cmd_que(1)
Feb 2 23:57:03 ubuntu kernel: [ 13.109865] scsi 0:0:1:0: Attached scsi
generic sg3 type 0
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Feb 2 23:57:03 ubuntu kernel: [ 13.110295] sd 0:1:0:0: [sda] Attached SCSI disk
New behavior:
Feb 3 10:50:11 ubuntu kernel: [ 3.684393] mpt2sas0: LSISAS2008:
FWVersion(08.00.00.00), ChipRevision(0x02), BiosVersion(07.15.00.00)
Feb 3 10:50:11 ubuntu kernel: [ 3.684397] mpt2sas0:
Protocol=(Initiator,Target), Capabilities=(Raid,TLR,EEDP,Snapshot Buffer,Diag
Trace Buffer,Task Set Fu
ll,NCQ)
Feb 3 10:50:11 ubuntu kernel: [ 3.684462] mpt2sas0: sending port enable !!
Feb 3 10:50:11 ubuntu kernel: [ 5.198735] mpt2sas0: host_add:
handle(0x0001), sas_addr(0x50030480004c4df0), phys(8)
Feb 3 10:50:11 ubuntu kernel: [ 8.256411] scsi 7:0:0:0: CD-ROM
TEAC DV-W28S-V D.0A PQ: 0 ANSI: 0
Feb 3 10:50:11 ubuntu kernel: [ 8.269509] sr0: scsi3-mmc drive: 24x/24x
writer dvd-ram cd/rw xa/form2 cdda tray
Feb 3 10:50:11 ubuntu kernel: [ 8.269514] Uniform CD-ROM driver Revision: 3.20
Feb 3 10:50:11 ubuntu kernel: [ 8.269706] sr 7:0:0:0: Attached scsi generic
sg0 type 5
Feb 3 10:50:11 ubuntu kernel: [ 11.061165] mpt2sas0: port enable: SUCCESS
Feb 3 10:50:11 ubuntu kernel: [ 11.061688] scsi 0:1:0:0: Direct-Access
LSI Logical Volume 3000 PQ: 0 ANSI: 6
Feb 3 10:50:11 ubuntu kernel: [ 11.062438] scsi 0:1:0:0: RAID1:
handle(0x011e), wwid(0x0c73dae32c7319bf), pd_count(2), type(SATA)
Feb 3 10:50:11 ubuntu kernel: [ 11.062444] scsi 0:1:0:0: qdepth(128),
tagged(1), simple(1), ordered(0), scsi_level(7), cmd_que(1)
Feb 3 10:50:11 ubuntu kernel: [ 11.062602] sd 0:1:0:0: Attached scsi generic
sg1 type 0
Feb 3 10:50:11 ubuntu kernel: [ 11.063018] sd 0:1:0:0: [sda] 488280064
512-byte logical blocks: (249 GB/232 GiB)
Feb 3 10:50:11 ubuntu kernel: [ 11.063312] sd 0:1:0:0: [sda] Write Protect is
off
Feb 3 10:50:11 ubuntu kernel: [ 11.063450] sd 0:1:0:0: [sda] Write cache:
disabled, read cache: enabled, doesn't support DPO or FUA
Feb 3 10:50:11 ubuntu kernel: [ 11.063728] sda: sda1 sda2 < sda5 >
Feb 3 10:50:11 ubuntu kernel: [ 11.087127] sd 0:1:0:0: [sda] Attached SCSI disk
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2011-02-17 13:58 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2011-02-17 13:58 LSI SAS2008-based controller does not export disks behind raid Artem Bokhan
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox