[PATCH] SCSI: trailing whitespace in Kconfig

[Stefan Richter <stefanr@s5r6.in-berlin.de>]

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
---

Applies after patch "SCSI: split Kconfig menu into two".
I didn't want to change whitespace in the portions that this patch
moved from drivers/scsi/Kconfig to drivers/scsi/Kconfig.lowlevel,
hence produced this follow-up.


 drivers/scsi/Kconfig.lowlevel |    8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

Index: linux-2.6.23-rc6/drivers/scsi/Kconfig.lowlevel
===================================================================
--- linux-2.6.23-rc6.orig/drivers/scsi/Kconfig.lowlevel
+++ linux-2.6.23-rc6/drivers/scsi/Kconfig.lowlevel
@@ -252,7 +252,7 @@ config SCSI_DPT_I2O
 	tristate "Adaptec I2O RAID support "
 	depends on !64BIT && SCSI && PCI && VIRT_TO_BUS
 	help
-	  This driver supports all of Adaptec's I2O based RAID controllers as 
+	  This driver supports all of Adaptec's I2O based RAID controllers as
 	  well as the DPT SmartRaid V cards.  This is an Adaptec maintained
 	  driver by Deanna Bonds.  See <file:Documentation/scsi/dpti.txt>.
 
@@ -457,7 +457,7 @@ config SCSI_GDTH
 	---help---
 	  Formerly called GDT SCSI Disk Array Controller Support.
 
-	  This is a driver for RAID/SCSI Disk Array Controllers (EISA/ISA/PCI) 
+	  This is a driver for RAID/SCSI Disk Array Controllers (EISA/ISA/PCI)
 	  manufactured by Intel Corporation/ICP vortex GmbH. It is documented
 	  in the kernel source in <file:drivers/scsi/gdth.c> and
 	  <file:drivers/scsi/gdth.h.>
@@ -491,7 +491,7 @@ config SCSI_GENERIC_NCR5380_MMIO
 	select SCSI_SPI_ATTRS
 	---help---
 	  This is a driver for the old NCR 53c80 series of SCSI controllers
-	  on boards using memory mapped I/O. 
+	  on boards using memory mapped I/O.
 	  It is explained in section 3.8 of the SCSI-HOWTO, available from
 	  <http://www.tldp.org/docs.html#howto>.  If it doesn't work out
 	  of the box, you may have to change some settings in
@@ -1261,7 +1261,7 @@ config SCSI_DEBUG
 	  each with multiple dummy SCSI devices (disks). It defaults to one
 	  host adapter with one dummy SCSI disk. Each dummy disk uses kernel
 	  RAM as storage (i.e. it is a ramdisk). To save space when multiple
-	  dummy disks are simulated, they share the same kernel RAM for 
+	  dummy disks are simulated, they share the same kernel RAM for
 	  their storage. See <http://www.torque.net/sg/sdebug.html> for more
 	  information. This driver is primarily of use to those testing the
 	  SCSI and block subsystems. If unsure, say N.

-- 
Stefan Richter
-=====-=-=== =--= -===-
http://arcgraph.de/sr/