[PATCH] jsm: Fixed EEH recovery error

[Lucas Kannebley Tavares <lucaskt@linux.vnet.ibm.com>]

There was an error on the jsm driver that would cause it to be unable to
recover after a second error is detected.

At the first error, the device recovers properly:

[72521.485691] EEH: Detected PCI bus error on device 0003:02:00.0
[72521.485695] EEH: This PCI device has failed 1 times in the last hour:
...
[72532.035693] ttyn3 at MMIO 0x0 (irq = 49) is a jsm
[72532.105689] jsm: Port 3 added

However, at the second error, it cascades until EEH disables the device:

[72631.229549] Call Trace:
...
[72641.725687] jsm: Port 3 added
[72641.725695] EEH: Detected PCI bus error on device 0003:02:00.0
[72641.725698] EEH: This PCI device has failed 3 times in the last hour:

It was caused because the PCI state was not being saved after the first
restore. Therefore, at the second recovery the PCI state would not be
restored.

Signed-off-by: Lucas Kannebley Tavares <lucaskt@linux.vnet.ibm.com>
---
 drivers/tty/serial/jsm/jsm_driver.c |    1 +
 1 files changed, 1 insertions(+), 0 deletions(-)

diff --git a/drivers/tty/serial/jsm/jsm_driver.c b/drivers/tty/serial/jsm/jsm_driver.c
index 96da178..8941b15 100644
--- a/drivers/tty/serial/jsm/jsm_driver.c
+++ b/drivers/tty/serial/jsm/jsm_driver.c
@@ -270,6 +270,7 @@ static void jsm_io_resume(struct pci_dev *pdev)
 	struct jsm_board *brd = pci_get_drvdata(pdev);
 
 	pci_restore_state(pdev);
+	pci_save_state(pdev);
 
 	jsm_uart_port_init(brd);
 }
-- 
1.7.4.4