[PATCH 2/2] serial: Use device_init_wakeup_flag() to make device wakeup-capable

[Simon Glass <sjg@chromium.org>]

We want the serial device to be wakeup-capable but not actually enable
the wakeup function. The original code results in making the serial
device wakeup-capable, then enabling and then immediately disabling
the actual wakeup feature on the device. This ends up in a
synchronise_rcu() in wakeup_source_remove() which can take some 15ms
to run, yet is entirely avoidable. The cost over 4 ports is about 600ms
on my Tegra2x system (with CONFIG_PREEMPT disabled).

Using the new function avoids this problem.

Signed-off-by: Simon Glass <sjg@chromium.org>
---
 drivers/tty/serial/serial_core.c |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/tty/serial/serial_core.c b/drivers/tty/serial/serial_core.c
index c7bf31a..a8b01db 100644
--- a/drivers/tty/serial/serial_core.c
+++ b/drivers/tty/serial/serial_core.c
@@ -2348,11 +2348,11 @@ int uart_add_one_port(struct uart_driver *drv, struct uart_port *uport)
 	 */
 	tty_dev = tty_register_device(drv->tty_driver, uport->line, uport->dev);
 	if (likely(!IS_ERR(tty_dev))) {
-		device_init_wakeup(tty_dev, 1);
-		device_set_wakeup_enable(tty_dev, 0);
-	} else
+		device_init_wakeup_flag(tty_dev, PM_WAKEUP_CAP);
+	} else {
 		printk(KERN_ERR "Cannot register tty device on line %d\n",
 		       uport->line);
+	}
 
 	/*
 	 * Ensure UPF_DEAD is not set.
-- 
1.7.7.3