[PATCH 7/7] UART: OMAP: Trivial optimisation of the probe and remove

[Shubhrajyoti D <shubhrajyoti@ti.com>]

The probe and remove may not be needed after initialisation and
remove the code could be be put in the devint and devexit section.

Cc: Govindraj.R <govindraj.raja@ti.com>
Signed-off-by: Shubhrajyoti D <shubhrajyoti@ti.com>
---
 drivers/tty/serial/omap-serial.c |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index cbc9d64..42ad500 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -1358,7 +1358,7 @@ static struct omap_uart_port_info *of_get_uart_port_info(struct device *dev)
 	return omap_up_info;
 }
 
-static int serial_omap_probe(struct platform_device *pdev)
+static int __devinit serial_omap_probe(struct platform_device *pdev)
 {
 	struct uart_omap_port	*up;
 	struct resource		*mem, *irq, *dma_tx, *dma_rx;
@@ -1489,7 +1489,7 @@ err_port_line:
 	return ret;
 }
 
-static int serial_omap_remove(struct platform_device *dev)
+static int __devexit serial_omap_remove(struct platform_device *dev)
 {
 	struct uart_omap_port *up = platform_get_drvdata(dev);
 
@@ -1654,7 +1654,7 @@ MODULE_DEVICE_TABLE(of, omap_serial_of_match);
 
 static struct platform_driver serial_omap_driver = {
 	.probe          = serial_omap_probe,
-	.remove         = serial_omap_remove,
+	.remove         = __devexit_p(serial_omap_remove),
 	.driver		= {
 		.name	= DRIVER_NAME,
 		.pm	= &serial_omap_dev_pm_ops,
-- 
1.7.4.1