[PATCH v2 00/10] ARM: Exynos: Add Exynos5420 SoC support

[Chander Kashyap <chander.kashyap@linaro.org>]

Exynos5420 is new SoC in Samsung's Exynos5 SoC series. This series adds
initial support for this SoC.

Changes since v1:

1. As not-dt platforms will not be supported from 3.11 onwards, following
   patches from previous patch series are dropped:
   "irqchip: exynos-combiner: set irq base as 256 for Exynos5420"
   "ARM: Exynos: initialize l2x0 cache controller only for cortex-a9 based SoCs"
2. Added device type property in cpu node in the following patch:
   "ARM: dts: list the CPU nodes for Exynos5250
3. Sorted out the nodes listed in based upon the physical addresses as suggested
   by Tomasz Figa.
4. As Tomasz is going to consolidate the secondary cpu power register address
   calculation in all possible scnarios, hence dropped the following patch:
  "ARM: Exynos: fix secondary cpu power control register address calculation"
5. Replaced the setup/remove)_irq calls with (request/free)_irq calls as
   suggested by Mark Rutland in patch: 
   "clocksource: exynos_mct: use (request/free)_irq calls for local timer
    registration"
6. Changed the registration of epll and rpll from pll35xx to pl36xx.
7. Changed driver data selection for serial port, based on ARCH_EXYNOS.
8. Changed the interrupt cells from 2 to 1 as suggested by Tomasz Figa.

Chander Kashyap (10):
  ARM: dts: fork out common Exynos5 nodes
  ARM: dts: list the CPU nodes for Exynos5250
  ARM: Exynos: Add support for Exynos5420 SoC
  serial: samsung: select Exynos specific driver data if ARCH_EXYNOS is defined
  ARM: Exynos: use four additional chipid bits to identify Exynos family
  clk: exynos5420: register clocks using common clock framework
  ARM: dts: Add initial device tree support for Exynos5420
  clocksource: exynos_mct: use (request/free)_irq calls for local timer registration
  ARM: Exynos: add secondary CPU boot base location for Exynos5420
  ARM: Exynos: extend soft-reset support for Exynos5420

 .../devicetree/bindings/clock/exynos5420-clock.txt |  201 ++++++
 arch/arm/boot/dts/Makefile                         |    1 +
 arch/arm/boot/dts/exynos5.dtsi                     |  111 +++
 arch/arm/boot/dts/exynos5250.dtsi                  |   80 +-
 arch/arm/boot/dts/exynos5420-smdk5420.dts          |   40 +
 arch/arm/boot/dts/exynos5420.dtsi                  |  104 +++
 arch/arm/mach-exynos/Kconfig                       |   10 +
 arch/arm/mach-exynos/common.c                      |   18 +-
 arch/arm/mach-exynos/include/mach/uncompress.h     |    7 +-
 arch/arm/mach-exynos/mach-exynos5-dt.c             |    1 +
 arch/arm/mach-exynos/platsmp.c                     |   12 +-
 arch/arm/plat-samsung/include/plat/cpu.h           |    8 +
 drivers/clk/samsung/Makefile                       |    1 +
 drivers/clk/samsung/clk-exynos5420.c               |  762 ++++++++++++++++++++
 drivers/clocksource/exynos_mct.c                   |   35 +-
 drivers/tty/serial/samsung.c                       |    4 +-
 16 files changed, 1288 insertions(+), 107 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/clock/exynos5420-clock.txt
 create mode 100644 arch/arm/boot/dts/exynos5.dtsi
 create mode 100644 arch/arm/boot/dts/exynos5420-smdk5420.dts
 create mode 100644 arch/arm/boot/dts/exynos5420.dtsi
 create mode 100644 drivers/clk/samsung/clk-exynos5420.c

-- 
1.7.9.5