[PATCH] serial: sirf: transfer more bytes once to decrease interrupts

[PATCH] serial: sirf: transfer more bytes once to decrease interrupts

[Barry Song]

From: Qipan Li <Qipan.Li@csr.com>

the current codes send 1 bytes, then after getting TX done interrupt,
send subsequent bytes. it causes redundant interrupts.
for example, if we have 3 bytes in TX buffer, the TX flow is:
1. send 1 byte
2. get TX down interrupt
3. send the left 2 bytes
4. get TX down interrupt

this patch moves to send more bytes and decrease interrupts, the new
flow is:
1. send 3 bytes
2. get TX down interrupt

Signed-off-by: Qipan Li <Qipan.Li@csr.com>
Signed-off-by: Barry Song <Baohua.Song@csr.com>
---
 drivers/tty/serial/sirfsoc_uart.c | 3 ++-
 drivers/tty/serial/sirfsoc_uart.h | 2 +-
 2 files changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/tty/serial/sirfsoc_uart.c b/drivers/tty/serial/sirfsoc_uart.c
index 9b4d71c..4102192 100644
--- a/drivers/tty/serial/sirfsoc_uart.c
+++ b/drivers/tty/serial/sirfsoc_uart.c
@@ -290,7 +290,8 @@ static void sirfsoc_uart_start_tx(struct uart_port *port)
 	if (sirfport->tx_dma_chan)
 		sirfsoc_uart_tx_with_dma(sirfport);
 	else {
-		sirfsoc_uart_pio_tx_chars(sirfport, 1);
+		sirfsoc_uart_pio_tx_chars(sirfport,
+			SIRFSOC_UART_IO_TX_REASONABLE_CNT);
 		wr_regl(port, ureg->sirfsoc_tx_fifo_op, SIRFUART_FIFO_START);
 		if (!sirfport->is_marco)
 			wr_regl(port, ureg->sirfsoc_int_en_reg,
diff --git a/drivers/tty/serial/sirfsoc_uart.h b/drivers/tty/serial/sirfsoc_uart.h
index 69a62eb..6a7ebf7 100644
--- a/drivers/tty/serial/sirfsoc_uart.h
+++ b/drivers/tty/serial/sirfsoc_uart.h
@@ -449,4 +449,4 @@ struct sirfsoc_uart_port {
 
 /* I/O Mode */
 #define SIRFSOC_UART_IO_RX_MAX_CNT		256
-#define SIRFSOC_UART_IO_TX_REASONABLE_CNT	6
+#define SIRFSOC_UART_IO_TX_REASONABLE_CNT	256
-- 
1.9.3