From mboxrd@z Thu Jan 1 00:00:00 1970 From: Ali Bahar Subject: Re: Config. tips sought: Serial-console garbles boot messages. Date: Thu, 5 May 2011 12:07:40 +0800 Message-ID: <20110505040740.GA32433@internetdog.org> References: <20110504042106.GA25237@internetdog.org> Reply-To: ali@internetdog.org Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Return-path: Received: from msr7.hinet.net ([168.95.4.107]:61888 "EHLO msr7.hinet.net" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1750733Ab1EEEGl (ORCPT ); Thu, 5 May 2011 00:06:41 -0400 Received: from suxbox.internetDog.org (220-141-34-152.dynamic.hinet.net [220.141.34.152]) by msr7.hinet.net (8.14.2/8.14.2) with ESMTP id p45455uP011194 for ; Thu, 5 May 2011 12:05:05 +0800 (CST) Received: from ab by suxbox.internetDog.org with local (Exim 4.72) (envelope-from ) id 1QHpqm-0008Ra-Qo for linux-serial@vger.kernel.org; Thu, 05 May 2011 12:07:40 +0800 Content-Disposition: inline In-Reply-To: <20110504042106.GA25237@internetdog.org> Sender: linux-serial-owner@vger.kernel.org List-Id: linux-serial@vger.kernel.org To: linux-serial@vger.kernel.org On Wed, May 04, 2011 at 12:21:06PM +0800, Ali Bahar wrote: > - serial console grables all the boot messages, until just at/before > the log-in prompt. Then, if I reboot, the 'shutdown' messages continue > to be seen correctly until boot-up begins again. It should go without saying that the baud rates etc have been set to match on both ends. Dev. Host Target's /proc/cmdline 115200 console=ttyS1,115200 console=tty0 Partity etc match, too.