Re: [PATCH v2 1/1] tty: i3c: add TTY over I3C master support

[Greg KH <gregkh@linuxfoundation.org>]

On Tue, Oct 24, 2023 at 10:31:51AM -0400, Frank Li wrote:
> On Tue, Oct 24, 2023 at 11:30:33AM +0200, Greg KH wrote:
> > On Mon, Oct 23, 2023 at 12:26:42PM -0400, Frank Li wrote:
> > > On Sat, Oct 21, 2023 at 07:02:40PM +0200, Greg KH wrote:
> > > > Note, your subject line needs to change.
> > > > 
> > > > On Fri, Oct 20, 2023 at 12:00:27PM -0400, Frank Li wrote:
> > > > > In typical embedded Linux systems, UART consoles require at least two pins,
> > > > > TX and RX. In scenarios where I2C/I3C devices like sensors or PMICs are
> > > > > present, we can save these two pins by using this driver. Pins is crucial
> > > > 
> > > > "Pins are crucial"
> > > > 
> > > > > resources, especially in small chip packages.
> > > > > 
> > > > > This introduces support for using the I3C bus to transfer console tty data,
> > > > > effectively replacing the need for dedicated UART pins. This not only
> > > > > conserves valuable pin resources but also facilitates testing of I3C's
> > > > > advanced features, including early termination, in-band interrupt (IBI)
> > > > > support, and the creation of more complex data patterns. Additionally,
> > > > > it aids in identifying and addressing issues within the I3C controller
> > > > > driver.
> > > > 
> > > > But where is the serial data ending up at?  Not a normal uart, what is
> > > > on the other end?  And do line settings mean anything here?
> > > 
> > > Currently, it use slave i3c code. 
> > > https://lore.kernel.org/imx/20231018215809.3477437-1-Frank.Li@nxp.com/T/#t
> > > 
> > > idealy build an i3c->usb dongle to bride it to usb acm. 
> > 
> > So no one has built such a thing yet to determine if any of this works?
> 
> It is easy to proof concept by I3C slave code and USB gadget ACM, then pipe
> two tty (ttyACM0 and ttySI3C0 together).

So you have not actually tested this?  why write a driver that no one is
using?

> Of we also can implement a USB to I3C class standard, base on this, reuse
> this tty driver at host side.

Is there a USB I3C standard?  I see i3c descriptors assigned by the
USB-IF, but haven't dug to see if there's more than that anywhere...

thanks,

greg k-h