[PATCH tty v4 5/6] serial: 8250: Check LSR timeout on console flow control

[John Ogness <john.ogness@linutronix.de>]

wait_for_xmitr() calls wait_for_lsr() to wait for the transmission
registers to be empty. wait_for_lsr() can timeout after a reasonable
amount of time.

When console flow control is active, wait_for_xmitr() additionally
polls CTS, waiting for the peer to signal that it is ready to receive
more data.

If hardware flow control is enabled (auto CTS) and the peer deasserts
CTS, wait_for_lsr() will timeout. If additionally console flow
control is active and while polling CTS the peer asserts CTS, the
console will assume it can immediately transmit, even though the
transmission registers may not be empty. This can lead to data loss.

Avoid this problem by performing an extra wait_for_lsr() upon CTS
assertion if wait_for_lsr() previously timed out.

Signed-off-by: John Ogness <john.ogness@linutronix.de>
---
 drivers/tty/serial/8250/8250_port.c | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/tty/serial/8250/8250_port.c b/drivers/tty/serial/8250/8250_port.c
index dbed5e5767541..719789013f6df 100644
--- a/drivers/tty/serial/8250/8250_port.c
+++ b/drivers/tty/serial/8250/8250_port.c
@@ -1984,16 +1984,20 @@ static bool wait_for_lsr(struct uart_8250_port *up, int bits)
 static void wait_for_xmitr(struct uart_8250_port *up, int bits)
 {
 	unsigned int tmout;
+	bool tx_ready;
 
-	wait_for_lsr(up, bits);
+	tx_ready = wait_for_lsr(up, bits);
 
 	/* Wait up to 1s for flow control if necessary */
 	if (uart_cons_flow_enabled(&up->port)) {
 		for (tmout = 1000000; tmout; tmout--) {
 			unsigned int msr = serial_in(up, UART_MSR);
 			up->msr_saved_flags |= msr & MSR_SAVE_FLAGS;
-			if (msr & UART_MSR_CTS)
+			if (msr & UART_MSR_CTS) {
+				if (!tx_ready)
+					wait_for_lsr(up, bits);
 				break;
+			}
 			udelay(1);
 			touch_nmi_watchdog();
 		}
-- 
2.47.3