[PATCH 1/2] jsm: removing the uart structure and filename on error

leitao
2010-02-02T01:35:53Z

If jsm fails to load, then remove the uart stuff, otherwise,
the things (as files), will be there forever (even when the module
is unloaded). If you try to reload the module, the following message
appears:

kobject_add_internal failed for ttyn1 with -EEXIST, don't try to
register things with the same name in the same directory.

This patch remove the uart things when the driver fails.

Signed-off-by: Breno Leitao <leitao@linux.vnet.ibm.com>
---
drivers/serial/jsm/jsm_driver.c | 1 +
1 files changed, 1 insertions(+), 0 deletions(-)

diff --git a/drivers/serial/jsm/jsm_driver.c b/drivers/serial/jsm/jsm_driver.c
index 108c3e0..12cb5e4 100644
--- a/drivers/serial/jsm/jsm_driver.c
+++ b/drivers/serial/jsm/jsm_driver.c
@@ -179,6 +179,7 @@ static int __devinit jsm_probe_one(struct pci_dev *pdev, const struct pci_device

return 0;
out_free_irq:
+ jsm_remove_uart_port(brd);
free_irq(brd->irq, brd);
out_iounmap:
iounmap(brd->re_map_membase);
--
1.6.0.2