Re: [RFC. PATCH] earlycon: Remove hardcoded port->uartclk initialization in of_setup_earlycon

[Matt Redfearn <matt.redfearn@mips.com>]

On 23/04/18 10:27, Michal Simek wrote:
> There is no reason to initialize uartclk to BASE_BAUD * 16 for DT based
> systems.
> 
> Signed-off-by: Michal Simek <michal.simek@xilinx.com>
> ---
> 
> It looks like from history that portclk = BASE_BAUD * 16 was setup to
> get on calculation on x86 (divisor = 1) but it shouldn't be needed on DT based
> system. That's why I think that there is no DT based system which really
> requires this line.

Hi Michal,

This is fine for the MIPS generic platform (tested on Boston board) 
which was broken by some earlycon changes a few versions ago. Also 
tested on a MIPS pistachio board. As long as the bootloader has 
configured the uart divisor, earlycon should work as long as my patch 
"serial: 8250_early: Only set divisor if valid clk & baud" is applied to 
avoid a bad divisor getting calculated.

Tested-by: Matt Redfearn <matt.redfearn@mips.com>

Thanks,
Matt

> ---
>   drivers/tty/serial/earlycon.c | 1 -
>   1 file changed, 1 deletion(-)
> 
> diff --git a/drivers/tty/serial/earlycon.c b/drivers/tty/serial/earlycon.c
> index a24278380fec..c12b1edcdd8e 100644
> --- a/drivers/tty/serial/earlycon.c
> +++ b/drivers/tty/serial/earlycon.c
> @@ -244,7 +244,6 @@ int __init of_setup_earlycon(const struct earlycon_id *match,
>   		return -ENXIO;
>   	}
>   	port->mapbase = addr;
> -	port->uartclk = BASE_BAUD * 16;
>   
>   	val = of_get_flat_dt_prop(node, "reg-offset", NULL);
>   	if (val)
>